0
it takes a special tool You can probally rent the Power Steering pulley removal tool from auto zone are any other reliable parts house. You will also need the tool to re-install the pulley.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you remove the pulley on a 1991 Suburban 5.7 power steering pump?
POWERSTEERING PUMP PULLEY PULLER (ADVANCE AUTO RENTS THEM)
How do you remove powersteering pully on a 1994 s-10 zr2 pickup with 4.3 vortec?
You will need a power steering pulley puller. It is designed to remove and install the power steering pulley. If you attempt to remove the pulley without it you will probably damage the pulley or the pump or both.
How do you remove a powersteering pump. Pulley in a 1997gmc k2500?
That requires a power steering pulley PULLER. Some parts stores will lone are rent it to you. It also requires a special tool to press it back on.
How to remove Powersteering pump on Mazda truck 2000 b 2500?
remove pulley - you need a power steering pulley puller and installer for ford - unbolt pressure feed line and bolts holding pump to bracket. Remove clip or clamp holding return line. Install new pump
The Pulley with a small steel rod came off power steering pump is this rod part of the pulley or the powersteering pump?
That is part of the pump. The pump is NG.
Belt diagram for Mazda mx-6?
the belt is simple to change you actually have two one is the powersteering belt and the other is ac belt. you need to first lower the top pulley closest to the front of the engine remove the belt of the three pulleys then lower the alternator using the tension screw and remove the pulley to install just follow in reverse
Do you need installation and removal kit to remove pulley on powersteering pump on 99 doddge durango?
Yes it requires a special puller to get the pulley off. They also make a tool to put it back on with because it has to be pressed on. You can just use a long bolt and a nut and washer to push it back on with too.
How do you change powersteering pumpin a 1996chevy astro van?
To change the power steering pump on the 1996 Chevy Astro van, you will first need to gather the correct tools. This job requires a special tool to remove the power steering pulley. You will disconnect the negative battery cable, remove the power steering pump pulley, remove the old pump, and replace it with the new pump by bolting the pump into the system.
How do you change the crankshaft position sensor on a 2001 Pontiac Grand Prix?
remove the front passenger wheel, remove the crank pulley, remove the crank sensor. you may need a GM special tool to remove certain bolts
Where is the pulley to tighten up belts?
theres gonna either be a tensioner bolt or tensioner pulley... u should beable to locate waterpump, crank, a/c, alternator, powersteering,idle pulley. knowing the car woulda been easier
How do you remove gm power steering pulley?
This requires a special puller for the specific type pump. Many retail parts supplier rent this type of puller.
How do you remove the crank pulley on Mitsubishi 3.0 v-6?
remove all belts,tensioners etc, remove pulley bolt, use HARMONIC BALENCER PULLEY to remove - DO NOT USE NORMAL PULLEY REMOVER - must be pulled from center of pulley not from outer edge
