There are reports from people stating that the use of WD-40 can help to remove the hardened wood stain from metal cranks on a window. It is best to never use anything that could rust or cause damage.
yes
Most of the ones I've seen just pull out. A few have had small nails holding them.
Here is some points that I used for my metal chair. Remove any loose pieces of rust using a wire brush. Remove the rest of the rust using a palm-sander. Remove sand using solvent from hand and legs. You must use high-quality oil-based spray paint specifically for outdoor designed to prevent rust.
you take it out,then put another one in!!!dah!!! 1. Disconnect power to oven. 2. Remove the 2 screws located in front on top of microwave securing grille. 3. Remove grille (slide to right then out). 4. Remove the screw securing metal light cover. 5. Remove the filter and metal light cover. 6. Remove screws securing bulb holder (if needed). 7. Remove light bulb Install new light bulb (20 watt halogen do not touch with skin). Reverse the above instructions for assembly
Look, I've been painting for a long time and all I can say to you is Good Luck. You will never remove the primer from on top of the paint. Sorry.
hardened steel metal metal metal metal
Rub it with Goof Off on a rough rag, it will soon become soft enough to peel an edge.
Soak them in water 3-4 days, then it can be removed with a metal spatula.
are they wind up windows or power windows? for power windows remove the door panel screws and pull. for wind up windows remove small metal snap rings behind the window handle. remove them and then remove all door panel screws and pull door panel off.
hardened steel
its formed or made of metal and has to be hardened.
Annealing is a term used for when metal is heat hardened
The only explanation of tempering is in metal manufacturing. Heat metal to cherry hot, plunge metal into water to quickly cool metal, hardened metal is created
A hacksaw is a hardened, toothed blade, fixed into a metal frame that has a handle. The hacksaw is used to cut through metal.
The finish is the metal and/or coating of the metal. Stailess steel or polished stainless steel. Bare metal or blued (looks black), colored case hardened.... etc...
hardened stainless steel should work
A common 'High Speed Steel' blade, as opposed to bi-metal or hardened.