key switch tumbler removal on 1998 astro
tumbler has slipped. hit key with mallet . but ignition keylock will soon have to be replaced
start by removing the shroud around the column. remove the assembly that houses the ignition switch, there is a spring catch located in the lock and tumbler, you will have to drill a small hole in the side to push this spring and while pushing the spring down rotate the switch and pull out.
Begin by removing the retaining ring at the top of your 1998 BMW ignition switch. The ignition switch will slide out. Remove the wiring harness.
do I remove steering wheel to change out ignition
I have the same problem, going to have a locksmith make sure its the ignition switch and cylinder and just not a key problem or a tumbler problem.
Remove the plastic 2 piece shroud around steering column so as to gain access to the housing the tumbler sits in. Find three Phillips screws to remove in holes in the lower piece. Turn the ignition key to the Run position. Insert a small tip screwdriver in the access hole on the bottom of the housing to push the spring-loaded tab which will free the tumbler so you can simply pull the tumbler out with the key. Installation is the reverse. Be sure tumbler with key inserted is set to the Run position. Depress spring-loaded tab, insert tumbler into housing hole with tab down. All the way in, turn key to the Lock (off position).
smoke a blunt
You will need to remove the retaining ring at the top of your 1998 Chevy Lumina ignition switch. Slide the ignition switch out. Remove the wiring harness.
I have a 98 neon and you take out the 3 screws on the underside of the steering colum .this take off the cover so you can see everthing.you will see a coulpe of screws that hold it in place ,unplug the wires and unscrew it .
Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.
Yes, wheels from a 1998 Mustang will work on a 2000 Mustang.