answersLogoWhite

0


Best Answer

The only sucessful way I have experienced is replacement.

There is another way. I detail headlights at used car dealers, what I do is drill a small hole on the lower edge of the light and let the moisture out. Using the lights will eventually evaporate the water. To clean the outside of the lens I product I sell called The CrystaLenz Headlight Restoration Kit.

User Avatar

Wiki User

โˆ™ 2015-07-15 21:36:09
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you remove moisture from under the headlight cover on your 1999 Jeep?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can moisture be removed from slk mbheadlite?

The headlight assembly or actually the side light assembly on early SLKs were notorious for collecting moisture. The lens and the glass cover is a sealed unit (not too tightly sealed apparently) and cannot be opened. These were replaced under warranty until you got one that didn't leak and collect moisture. There is no easy way to remove this moisture from the outside.


Where is the fuse for headlight for infiniti I30?

Under the hood by the battery. there will be a black plastic cover with pressure tabs you will need to remove.


How do you change a headlight bulb on a 2000 cavalier?

you have to remove the headlight assembly, there are 2 bolts for each side. To get to the bolts, you'll need to remove the plastic cover that goes across the front just under the hood. After you do that you can undo the bolts and access the bulbs.


How do you replace the headlight switch in a 1988 Ford F-150?

First remove the wiper and headlight switch knobs. They will pull off with force, then you will under stand how they go back on. Remove cover under dash to view fuses. Take two screw out that hold the fuse panel. The dash cover around the wiper and headlight switch actually pops off when pryed on. Once this cover is off remove the nut around the headlight switch and it will pull out, but you need to get the fuse panel out of the way. The switch it self has a pull out bar that can also be taken out by depressing the button brad on the switch itself.


How do you remove the headlight assembly on a 1998 ford escort?

There are two ten mm bolts on top in the plastic header panel which must be removed. There are two more under the bumper cover. You must remove the bumper cover to access them.


How do you remove the headlight assembly located on a 1998 Ford Escort?

There are two ten mm bolts on top in the plastic header panel which must be removed. There are two more under the bumper cover. You must remove the bumper cover to access them.


Where is the radiator fan relay on a 2003 Jeep Grand Cherokee?

It's under the front right headlight, need to remove headlight assembly and cut hole to get to relay, which is under the plastic frame that holds headlight assembly. It is located under the hood on the left hand side . next to the battery you will see a black or gray box. you should be able to squeeze the cover and pull it off it will tell you on the underside of the cover whioch exact fuse it is.


How do you change the high-low beam headlight bulb on a 1999 Grand Am GT?

remove the ram air cover under hood. there are 2 L shaped brackets that hold each headlight in car. lift / pry these out using pliers to gain access to rear of headlight.


How do you replace a headlight bulb on a 2005 Chrysler Pacifica?

you have to remove the two screws on top of the headlight assembly then you have to reach under the headlight between the headlight and the bumper and pull it out.i'd use a piece of cloth to cover the chrome on the bumper this vaw you don't scratch it.once you pull out the assembly then unplug it and change the bulbs you want..


2000 jeep grand Cherokee fan will not turn off?

The radiator fan relay has failed. The relay is under the front bumper cover under the right front headlight. The easyist way to access the relay is to remove right front headlight and drill a 1.5 inch hole to remove. Otherwise the entire front bumper has to be removed.


How do you change the O2 sensor in a 2000 Daewoo Lanos?

There is a plastic cover that needs removed. Its the cover that is inside the passenger side wheel well. To remove this cover properly there are three bolts and two nuts. One of the nuts is located under the headlight on the frame, so the headlight needs removed. It is the located on the pipe that comes out the exhaust manifold.


Your 02 jeep grand Cherokee fan radiator will not shut off?

The radiator fan relay has failed. The relay is under the front bumper cover under the right front headlight. The easyist way to access the relay is to remove right front headlight and drill a 1.5 inch hole to remove. Otherwise the entire front bumper has to be removed.

People also asked