2001-2002 I know the screws are behind the trunk panel. Two on each side I think and the ones in the back.
To remove the rear bumper cover on a 1993 Ford Taurus wagon, the lights need to be disconnected in the rear. Once all electrical connections are disconnected in the rear, remove the taillights and the fuel filler overflow hose. Remove any nuts and bolts holding the bumper cover on. Using needle nose pliers, pop the push pins around the bumper cover upwards. Slowly pull on the bumper to remove it.
,
To remove the rear bumper on the 2005 Nissan Sentra, you will first need to remove the rear bumper cover by using a flat tool to pry the pins. Then, access the bolts holding the bumper to the frame of the vehicle and remove the nuts. The bumper will then lift off.
easy
I have a small dent need to remove it
1. If needed raise vehicle and support it on Jack stands 2. Remove the retaining screws in the wheel wells and along the upper and lower edges of the bumper cover. Remove the tail light housings. Remove the rear trim plate and pull luggage compartment trim out for access then remove the remaining bumper cover retaining screws. Remove the bumper bolts 3. On station wagons remove the rear window washer fluid reservoir for access to the bumper retaining bolts. The remaining bumper bolts are accessible from below 4. Pull the bumper and cover assembly out and away from the car
how to remove 2013 passat rear bumper
There are mounting screws located on both sides of the rear wheel arch, loosen then and the bumper will come right off.
Remove rear bumper on 99 ford tarrus
how do you remove and replace rear bumper on an xtype jag
The rear bumper cover is fastened to the car in exactly 9 places. Follow this procedure:Raise the trunk lidRemove the three push-in fasteners in the center of the top of the bumper, directly underneath where the license plate holder would be when the trunk lid is closedJack up the car and remove the driver's rear wheel
Removing the Rear Bumper of a Passat...