i wont to change my shifter but cant take off old one
fluids are fine, no codes, and it wont shift past 2nd gear. any help?
Just remove the console and you can get to it.
The linkage for the brake pedal lockout is down on the shifter and when coke and coffee is spilled on the console, it runs on it and keeps it from working. You have to remove the console and clean the linkage.
Remove the bolts holding the console down and remove.
To remove the console shift knob on the AT 1993 Olds Achieva, first pry the cover from the top of the shift knob. Then, access the single screw inside the cover of the shift knob and turn it counter-clockwise to release the knob.
Front Floor Console Replacement Removal Procedure 1. Apply the park brake. 2. Remove the floor console bolts from the sides of the console. Adjust the front seats as required. 3. Shift the transaxle to 2. 4. Remove the screw from the shift handle. Remove the shift handle. 5. Pull the floor console rearward slightly. Disconnect the electrical connector at the front of the floor console. 6. Remove the floor console. 7. Remove the wiring harness. 8. Remove the HUD switch, if equipped. 9. Remove the traction control switch. 10. Remove the accessory power receptacles. 11. Remove the armrest and the hinge. Installation Procedure 1. Install the armrest and the hinge. 2. Install the accessory power receptacles. 3. Install the traction control switch. 4. Install the HUD switch, if equipped. 5. Install the wiring harness. 6. Position the floor console to the vehicle. 7. Connect the electrical connector at the front of the floor console. Slide the floor console toward the front of the car. 8. Install the shift handle. Install the shift handle screw. 9. Shift the transaxle to P. Notice: Refer to Fastener Notice. 10. Install the floor console bolts. Adjust the front seats as required. Tighten the bolts to 10 N.m (89 lb in). 11. Release the park brake.
Begin by removing the 2002 Jeep Liberty shift console retaining bolts. Lift the shift console up and the light bulb will be visible. Take hold of the light bulb, push in and turn at the same time to remove it. Reverse the process to install your new shift console light bulb.
if you dont have a slot on console you have to pop remove the center console plate on top there a release under there
* Remove the shift lever knob,console and shift boot * Disconnect the shift and select cables from the shift control assembly * Remove the large shift cable retainer plate and detach the cables from their bracket on the shift control assembly base * Remove the shift control assembly retaining nuts and remove the shift control assembly
lift up the center plate on the console were your gear select is after you remove your shift lever and all the lever pieces and there you can remove the top of the console and the bottom has 4 bolts 10mm remove those and you shift your car all the way down to first or low gear and lift it up un plug the harness and there you go
Pry out the gear selector trim with a screwdriver and lift it out.Open the console lid and remove the screws on the bottom.Remove the screws on both sides of the console.Lift the console up and over the shift lever.Disconnect any electrical connections and remove the console from vehicle.
Are you referring to the knob on the shifter or the entire stick. It will help if you can tell us more about what's goin' on. FriPilot