answersLogoWhite

0


Best Answer

Disconect neg on battery, remove outer primary, remove jackshaft( keep parts in order when removing) remove rear tire, a motorcycle lift works good, disconect positive to starter, remove 2 1/4 inch allen bolts from starter, pull starter and catch spacer(notice direction of spacer it only goes back the way it came out.) Go to rear of swing arm pull starter from rear by the rubber fender guard. Replace in order the way it came out. It can be a pain but it's the only way I could replace mine.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

14y ago

If it is like any I have worked on you take all the blts out from the starter motor side and what is holding you back is the gear that is located inside so you must take off your primary cover and you will see it and it is very simple to remove from there! Be prepared to buy new primary cover gasket for it as they really need to be replaced every time you take primary cover off, hope this helps and best of luck to you.--DC

This answer is:
User Avatar

User Avatar

Wiki User

15y ago

4.6 L engine. Ford has the starter tucked nicely in there. It is best to have the car on a hoist. There are 3 bolts to come out, and the 3rd one is where you have to really bend your hand. On a hoist it will take about an hour to remove and replace. Just make sure the exhaust is cold.

This answer is:
User Avatar

User Avatar

Wiki User

15y ago

Remove the battery cables. Remove the positive cable from the starter. Loosen all the bolts that hold the starter in place. Remove the starter from the car.

This answer is:
User Avatar

User Avatar

Wiki User

10y ago

on a hot start the starter just about turns over and makes a loud clanking sound

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove starter harley Davidson electra glide 2005?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change starter solenoid on a Harley Davidson?

Remove the starter. the solenoid is mounted on the starter.


How do you remove starter Harley Davidson Fatboy 1998?

you need to remove the left primary case and remove the gear from the end of the starter shaft. then you can remove the mounting bolts and the starter will slide out.


How do you remove starter bendix 0n 1985 harley Davidson fxr?

how do i replace the bendix drive in my 85 harley fxrs


What size wrench do you need to remove the transmission plug on a 2006 Harley Davidson Electra Glide?

A 5/8" socket wrench.


Oil plug location electra glide?

The Harley-Davidson Electra Glide motorcycle oil plug is located on the bottom of the oil pan. You can remove the oil plug with a half inch ratchet.


How do you replace a stator on a 1995 Harley road king What does the stator do?

Remove the cables from the 1995 Harley-Davidson Road Tank motorcycle starter. Remove the retaining bolts. Reverse the process to install the new starter. The starter turns the engine over so it can start.


How do you remove starter on 1993 Harley Davidson FXR?

You buy a service manual and study it very carefully. It's worth it, cost is about $30.


How do i repair a starter on a 1988 Harley Davidson flhtc?

simply put, buy a repair manual; you are going to need it. Be prepared to remove the primary cover.


How do you remove the starter on 1987 Harley Davidson?

Disconnect battery negative terminal, drain primary chaincase, remove outer chaincase cover, remove jackshaft end screw, disconnect positive terminal & solenoid terminal from starter, remove two allenhead starter mounting bolts, lift out starter. To reinstall starter reverse procedure.


How do you remove a starter from a 1998 Dyna Harley Davidson?

Disconnect battery negative terminal, drain primary chaincase, remove outer chaincase cover, remove jackshaft end screw, disconnect positive terminal & solenoid terminal from starter, remove two allenhead starter mounting bolts, lift out starter. To reinstall starter reverse procedure.


Where is the location of the oil drain plug on a 2000 harley Davidson electra glide classic?

The oil drain plug on a 2000 Electra glide is under the oil pan towards the front of the engine. Make sure that you remove this plug instead of the transmission drain.


How do you remove a starter on a rev tech motorcycle engine?

REMOVE OUTER PRIMARY COVER. REMOVE JACKSHAFT NUT( THE SMALL NUT ON THE SMALL GEAR TOP REAR) TWO SCREWS(BOLTS) THAT RUN INWARD THRU STARTER BELOW OIL TANK REMOVE STARTER FROM BACK OF INNER PRIMARY. IF YOU BUY A HARLEY DAVIDSON SERVICE MANUAL, THE PROCEDURE SHOULD BE THE SAME AS HARLEY'S. LAKELIZARD