They are tied to either the brake lights or the tail lights.
how to change the rear tail light bulb on a 2004 Nissan maxima
open the hatch there are two screws remove them and the tail light will come out, after that there are three more screws remove them and you can get to the bulbs to replace them
Remove the seat.
in side the trunk there are is gonna be carpwenting covering the metal part of the body you will see plastic screws remove that then remove the tail gate it self and your be able to remove the tail light in side the trunk there are is gonna be carpwenting covering the metal part of the body you will see plastic screws remove that then remove the tail gate it self and your be able to remove the tail light
I have a 2003 Outlander and tail light is similar- check out the WikiAnswer for the 2003 which helped me remove my tail light assembly.
The tail light assembly on a 2004 Chevy Suburban can be removed by taking out the retaining screws and twisting the bulb assembly. The assembly can then be pulled from the vehicle.
you have to drop the tailgate and remove the two screws on the side of the taillight lens.
Question isn't clear. Are you asking how do you replace the bulb -OR- how to remove the entire lens assembly?
trying to install bulb in 2007 maxima need info on how to
up your tail pipe
I think it's in the trunk on the right side, around where the tail lights are. Just remove the trunk floor and look to your right. It should be on the side.
from inside trunk remove trunk liner to expose back side of lights locate screws and remove install is the reverse
Probably have a short in tail light or license plate light. It could also be a bad bulb. If bulb, see sources and related links below for bulb information.
You can access the Nissan taillights from the cargo compartment. Remove the tail light assembly cover. Remove the tail light wiring harness. Remove the tail light assembly retaining bolts.
You will need to remove the tail light covers in the cargo compartment. Remove the wiring harness. Remove the tail light assembly retaining bolts.
Remove the wiring harness from the tail light assembly in your 2005 Mercury. Remove the tail light assembly retaining bolts. The tail light assembly will come out.
You may have to replace the headlight switch since your tail lights are tied into the same switch.
In the fuse box near passenger headlight its a 15amp fuse on the very end at the top. You need to release the fuse box and pull it up.It is inside a blackbox
Check bulbs & fuses first. If still a problem you will need to start looking at possible wiring issues
Start with new fuses...
tke a screwdriver and remove the screws and take out the tail lamp. otherewise take a hammer and break the tail lamp
Remove two screws holding tail light assembly. Pull or Pry out tail light assembly. Locate center wire plug harness, turn to remove, pull out bulb, push new bulb in.
Remove tail light housing. Remove lamp. Replace lamp. Replace tail light housing.
Under the Dragon's Tail was created in 2004.