THESE DIRECTIONS COME DIRECTLY FROM GM 1. REMOVE THE WINDSHEILD GARNISH MOLDING. 2. RELEASE THE FRONT ASSIST HANDLE FROM THE HEADLINER.(TO DO THIS YOU MUST POP OFF THE COVER ON EITHER SIDE AND YOU WILL SEE A RETAINER CLIP ON THE OUTER EDGES OF EITHER SIDE. INSERT A SMALL PICK OR FLAT HEAD SCREW DRIVER AND PRESS THE CLIP TOWARDS THE INSIDE OF THE HANDLE. THEN PRESS THE END OF THE HANDLE OUTWARD AND PULL IT SHOULD RELEASE.) 3. RELEASE THE UPPER PORTION OF THE CENTER PILLAR TRIM PANEL. 4. OPEN AND ROTATE THE SUNSHADE PARALLEL TO THE SIDE WINDOW. 5. INSERT A SMALL TOOL INTO THE BEZEL ACCESS HOLE. 6 PUSH UPWARD ON THE TOOL WHILE ROTATING THE SUNSHADE PARALLELL TO THE WINDSHEILD. THE SUNSHADE PIVOT ARM BEZEL SHOULD APPEAR TO BE RECESSED INTO THE BEZEL. 7. APPLY OUTBOARD PRESSURE TO THE SUNSHADE WHILE THE SUNSHADE IS PARALLEL TO THE WINDSHEILD. 8. PULL THE SUNSHADE DOWNARD WHILE MAINTAINING OUTBOARD PRESSURE TO THE SUNSHADE. YOU WILL NOTICE A SEPARATION BETWEEN THE HEADLINER AND THE SUNSHADE BEZEL. 9. IN ORDER TO REMOVE THE SUNSHADE FROM THE HEADLINER, CAREFULLY GRAB THE HEADLINER AT THE WINDSHEILD PILLAR AREA AND APPLY DOWNARD PRESSURE WHILE GENTLY ROCKING THE SUNSHADE UP AND DOWN. 10. REMOVE THE INBOARD RETAINER SCREW. 11. REMOVE THE INBOARD RETAINER FROM THE HEADLINER. 12. IF THE VEHICLE IS EQUIPPED WITH LIGHTED SUNSHADES REMOVE THE ELECTRICAL CONNECTORS FROM THE HEADLINER.
Can you tell me how to remove the box covering the spark plugs in a 2002 gmc envoy slt 4.2
GMC Envoy was created in 2002.
where is the oil filter located on an 2002 GMC Envoy
Riunning lighs not working 2002 gmc envoy
how do you remove 4x4 switch on a 2007 gmc envoy
How to change brake pads on 2002 GMC Envoy front brakes.
There are 2 BCM's on my 2002 GMC Envoy. The first in under the left side of the rear seat. (This is the one I had to change on mine) The second is in the rear liftgate. You'll have to remove the panel to get access to it.
The GMC Envoy was produced in 1998 and not again until 2002. The Envoy was produce until 2009. GMC is no longer producing a vehicle with the name Envoy.
How do you remove the fan shroud on a 2004 get envoy
My 2002 GMC Envoy won't start,no lights come on when trying to jump start the battery. And my key won't remove from the ignition. What's should i do?
where is the blower motor resistor located on 2002 gmc envoy?
One can purchase a used 2002 GMC Envoy in online car-selling websites that sell used cars. In addition, one can purchase a used 2002 GMC Envoy from one's peers if one of those peers have the car.
The axle/hub nut torque on a 2002 GMC Envoy is 103 ft.lbs.
Remove the transmission dipstick and read it, it will tell what is the correct fluid to use.
They have 6.75" front and rear.
no can do,there is no off & on switch.
The starter location on a 2002 GMC Envoy is on the passenger side of the engine compartment. It is just below the manifold. Both the starter and starter solenoid are located here.
2004 GMC Envoy is on page 28 http://documents.victorytechnologies.com//documents/product/929.pdf 2004 GMC Envoy is on page 28 http://documents.victorytechnologies.com//documents/product/929.pdf
They are located under the air inlet grill directly in front of the windshield. You have to remove the wiper arms and antenna to remove the grill.
No adjustment is possible.
To fix a loose vacuum hose on a 2002 GMC Envoy, it can be clamped with a small hose clamp. Use a metal clamp that can be adjusted to fit the small hose.