2000-2005 Dodge & Plymouth Neons
Child Car Seat

How do you remove the Rear speakers in a 2003 Dodge Neon SXT with the child safety seat anchors?

585960

Top Answer
User Avatar
Wiki User
2011-09-12 20:34:20
2011-09-12 20:34:20

Take off the panels above where your 6x9's are, they pull right out. Stick your fingers in between the edges of the chair and the carpet in the back, and just pull it out. its more like a cardboard with carpet on it, anyways your speakers will be exposed and just start unscrewing them. That's it!

^this wont work....you have to remove the rear seat, then you can take the carpeting/board off which will expose the speakers

here is a link with photos on how to do thishttp://s42.photobucket.com/albums/e307/wharpig/Neon%20Speaker/

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Remove rear seat, them remove rear deck to get to the speakers.

User Avatar

remove back seat then pull out and remove from mounting tray then that's it

User Avatar

Remove the back seat with a number 55T torque screw socket and then you can slide out the back panel to get to the speakers.

User Avatar

Carefully remove the A pillar cover.. Then pop out the speaker screen..

User Avatar

Small screwsriver pop the metal speaker covers off..easy access to speakers from there

User Avatar

Dodge does not use inertia/safety switches.Dodge does not use inertia/safety switches.

User Avatar

They are usually 3.5" speakers.

User Avatar

link here: http://www.craigcentral.com/durango/speakers.asp

User Avatar

You have to remove the back seat.Remove lower seat coushin. it pulls up then outRemove back part of the coushin 2 bolts in each lower cornerremove retaining clips the hold package tray in place and remove package trayremove the speakersEasy as that :)

User Avatar

Sony is the brand speakers for the 2011 Dodge grand caravan.

User Avatar

Which speakers and which moulding exactly are you refering to? If you are talking about the door speakers: Just remove the screws on the panel and inside of the door handle and inside of the armrest on the door there is a screw. Then you must remove the door handle by using a screwdriver to pry off the clip behind the door handle. After that just pop the panel off.

User Avatar

The front speakers, in your 2006 Dodge, will measure three inches by four inches. The back speakers will measure six inches by eight inches.

User Avatar

No safety/inertia/reset switch on a Dodge.

User Avatar

according to the JL Audio website. A dodge magnum standard SXT or SE setup has six speakers total. on the dash it has two 3.5" speakers; 6.5" speakers on the two front doors; and two 6x9" speakers in the rear.

User Avatar

Which speakers are you trying to replace? Front or rear?

User Avatar

You have to remove the vent & bezel assembly from below the radio first, then the entire dash bezel from around the instrument cluster & radio.

User Avatar

there are NO speakers in the "rear" doors of a Neon.

User Avatar

5.75 inch speakers are in the front and rear doors

User Avatar

Doesn't have anchors, you have to use the seatbelt.

User Avatar

front dash tweeters- 3.25" door speakers- 6.5" rear deck speakers- 6x9"

User Avatar

can you by pass a safety neutral switch on a 2001 dodge neon

User Avatar

dodge factory speaker sizes are 6"x9"


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.