== == == == ALTHOUGH THE RADIO IS ELECTRONICALLY REGISTERED TO THE SPECIFIC VEHICLE IT IS INSTALLED IN, AND THEORETICALLY CANNOT BE USED IN ANY OTHER VEHICLE, EVEN ANOTHER MAGNUM, WITHOUT SOME FACTORY OR DEALER RE-PROGRAMMING, REMOVING IT SHOULD NOT BE A PROBLEM.
INSTALLING A NEW RADIO MAY OR MAY NOT BE A DIFFICULT TASK.
THE ONLY WAY I KNOW THIS IS THAT MY SUPPOSEDLY UNSTEALABLE '05 R/T WAS RECENTLY STOLEN, AND WAS RECOVERED TODAY, SANS RADIO. IT STILL STARTS AND APPARENTLY RUNS, ALTHOUGH I AM HAVING IT TOWED TO THE DEALER (THEY STOLE THE PLATE, TOO).
FYI, THEY STOLE THE CAR BY BURGLARIZING MY HOME AND TAKING THE KEY, PROBABLY THE WAVE OF THE FUTURE FOR CARS WITH TRANSPONDER KEYS.
THEY APPARENTLY REMOVED OR UNSCREWED A FRONT BEZEL, WHEREUPON THE RADIO/HEATER PANEL SWINGS OUT FROM THE BOTTOM. THEY THEN REMOVED THE RADIO FROM THE ASSEMBLY -- THE HVAC CONTROLS ARE STILL THERE. I HAD THE Boston ACOUSTIC W/SIRIUS SYSTEM. THE SPEAKERS APPEAR TO BE INTACT.
Remove the decorative radio retaining plate. Remove the radio retaining screws. Remove the wiring harness, from the back of the radio.
There is no fuse for the speakers, only the radio.
Look in your owners manual if you have it and it will tell you.
Go to the dodge place and ask THEM to remove it
how do you remove the stock radio on a 1996 lexue es300
On the RAK radio hold down the TIME button.
can youi show me how to pop off the panel to remove the radio in the 2007 dodge ram.
Begin by removing the decorative radio retaining cover. Remove the radio retaining screws. Slide the radio out, remove the wiring harness and the antenna cable from the back of the radio.
look in your owners manual for the position of the radio fuse in the fusebox.
you cant you cant
To change the clock on your 2005 dodge Magnum you need to turn off the radio and hold the button that has clock set on it until the time flashes then you turn the tuner knob that's on the right clockwise to go increase time and counterclockwise to bring numbers down. Good luck.
just pull it out ( bezel for 6cd radio)watch out for tabs though.
remove dash srews then take dash off radio will be visable take out mounting srews then unplug plugs
Pull out on the little black piece at the same time as the coax itself. It will feel like it is going to break, but it will come out.
* Remove the ashtray and ashtray holder * Remove the radio and mounting plate screws and lower the radio and unplug the electrical connector and antenna lead then push the radio out of the dashboard
Park it in the Mexican part of town with Mariachi music playing and they will remove it for you.
Remove the Phillips-head screw behind the bag clip to the right and below the radio. The bezel is then held in place with friction clips. Just pull to remove.
The stock radio on a 2008 Ford F550 is removed by removing the trim and cover panels, disconnecting the wiring harness, and taking out the retaining screws. The radio can then be slid out of its housing and removed.
1st Remove the dash Panel it easly snaps off. then it exposes the radio bracket screws remove those then the radio slides out then remove the cables and antenna from the back and your Done!! Good Luck Matt
im trying to find out the same thing
remove the exterior trim peace that surrounds the outer edges of the radio. Then there should be either two 10mm bolts or four phillip head screws holding the radio in place remove them and gently remove the radio from it slot and then unplug the wire harnesses and antenna in the back of the radio. repeat in reverse to reinstall.
You have to remove the vent & bezel assembly from below the radio first, then the entire dash bezel from around the instrument cluster & radio.
how do you remove the stock radio from a 2000 ford focus zx3 Go to walmart in the car stereo section. In there, there are these packs of 2 U-shaped metal rods. If you buy theses, stick them in the correct holes in the radio then it will pop right out.