try removing the battery and putting it back in.
i have bought an LG T300 and I am unable to remove the back cover. Can some body tell me how?
Remove cam gear, remove broken back cover, replace back cover, replace timing belt.
Remove the derby cover on the back end of the primary cover. Behind it you will find a spring and nut. Both slide off. Remove the nut behind that. You have to turn the screw inside it to get it out. remove the bolts from the primary cover and pull if off, AFTER you drain the oil. Once you are done, install the cover and put the first nut back on and turn the screw, just until it bottoms and then back out about 1/8 turn. Put the other nut back on and the spring. Put in your oil and install the cover.
No, but it the LG Rumor2 and LG Cosmos both use the same skins. I would know this because I have the Rumor2. You can trust me. Hope this helps. -Present321
the cover does not come off, you must remove the entire light assembly and remove the bulb from the back side
You don't, it slides back.
Take the remote and flip it over. On the back you will see a cover were the batteries are, remove the cover. after removing cover take old batteries out and replace with new ones and then put the cover back on.
Yes; the Rumor2 has been discontinued by Sprint because the Rumor Touch, its successor, has become too popular. However, the Rumor2 is still available through some carriers like Virgin Mobile.
Remove the small screw on the back that you would remove to change the default back cover with the belt-clip cover, remove the battery (small round silver thing) underneath the cover. Leave the pokewalker open like that in a warm dry place for two to three days until it has completely dried out. Put the battery back in after the pokewalker has dried out and hopefully it will still work.
If you're asking how to remove the back cover panel:1. Looking at the back of the monitor, you'll see two screws near each bottom corner. Remove those.2. Inserting a thin tipped standard slotted screwdriver, pry between the back cover and front cover (bezel) gently.3. Lift the screwdriver to pry the front bezel away from the monitor.4. Continue around the edges until you can lift the back cover off the monitor.note: be careful around the corners. Take your time.
You have to remove the back black cover held on by 4 clips that look like luggage clips. Once you remove those you have to lift cover, that will give you acess to 3 nuts that relase back cover then you have access to bulb connections.