get in your back seat. feel along the bottom edge of your seat. you will feel two bolts. remove these and the seat will come right out. just did this to my 91 cutty to see if i could get to the fuel pump from there.
6
696
6969
12
12
dont listen to him...he cant spell
First you remove the lower back seat, and the bolts that secure the upper will be exposed. Remove them and lift out upper back seat.
I have a 1991 Cutlass Supreme and I had to use a flex ratchet to replace the back 3 plugs. Other than that I was told by a mechanic friend that the motor has to come out to do this.
its in back valve cover at fire wall i removed the plenum from the intake manifold to get at it.
grab the end of the key sticking out and pull straight back.
Remove the wiring harness from the back of your 1995 Oldsmobile Cutlass blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.
remove the neg (-)battery pole and plug in back in about 5-10 minutes
It is mounted on top of the transmission. You'll have to remove the airbox and peer back toward the firewall. Mine has two bolts that connect it to the transmission. The shifter rod is held on by one nut.
under the back license plate
Begin by removing the decorative radio retaining cover. Remove the retaining bolts. The radio will slide out. Remove the wiring harness and the antenna cable from the back of the radio.
You can't, its done by the computer if you have a knock noise, replace the knock sensor. its locate on the back of the engine near the alternator.
I have 90 cutlass supreme. look under center of car for gas tank. should be on back end of the tank. need to jack up high enough to get at.
The 1992 Oldsmobile Cutlass Supreme 3.1 liter engine starter is located on the bottom of the engine near the back. You can follow the positive battery cable directly to the starter.