there is 8 bolts, 4 on each side that run up the middle of the frame, also you have 2 or 3 ground straps near the fuel tank, dont forget to undo the fuel neck......3 screws have to open the fuel door to reach them....last but not least the tail light plug.....on the driverside frame rail near the rear. P.S. better have a few buddies or a lift cause it weights about 3-4 hundred pounds
remove the bed of the truck.....
Remove the fuel tank or remove the bed.
How to remove bed rails from a dodge truck
There are several bolt and nut sizes associated with the 1997 Chevrolet truck bed. The bolt and not sizes range from a half inch to three-quarter inches.
It will look alright if its the step side bed but will not if its fleetside
get under neath the truck remove bolts that hold bed to truck. disconnect wiring that goes to lights on bed. lift off bed
Yes, so long as they're the same length bed.
no it wont just bolt on....
can a tow bed be wielded to frame of a truck or does it have to be boilted down
If the extended cab is a short bed, yes. Same generation vehicle.
Unbolt the bed from the frame. Its easiest if you have a machine to lift it up. If not, just jack up the back end to decompress the suspension to give you more room.
remove the bed bolts and disconnect the wiring harness behind the bumper for the tail lights
It is inside of the gas tank. Will need to remove bed or fuel tank to service the pump.
It is inside of the gas tank. You will need to lift bed up or remove the gas tank to get to it.
To protect the bed of a Chevy truck a bed liner should be used. There are a few different materials that bed liners are made of but they are sprayed on. Some of the materials are Polyurethane and Polyurea.
This is un-real...the question is..."How much does a Chevy SilveradoTruck bed weigh?"The relevant assembly in question is not the entire truck, only the BED!So, I suppose, my search for the ACTUAL and CORRECT answer continues...
Yes, But it won't look right. 1988 is when chevy redesigned the body / changed it.
There are several bolts through the frame. Disconnect the fuel filling hoses, electrical then remove the nuts from the bolts that go through he frame. The bed should lift off easily then.
the fuel pump is inside the fuel tank so u will have to remove the tank or the truck bed;;
Disconnect wiring harness, unbolt bed and with the help of 3 more helpers lift bed up and remove bed from truck. It may matter what year and model truck you have but you may have to remove rear bumper also.
In the fuel tank. You either have to remove tank, or remove bed to access.
Direct bolt on. NO. You will have to modify the bed mounting brackets to put a 98 on a 2003 and then none of the body lines will match up and the truck will look REAL FUNNY.