answersLogoWhite

0


Best Answer

Just went through this today myself the are 3 screws you need to remove the first one is very easy and out in the open to the top right of the door panel the second is behind the door handle go like you are going to open the door and you will see the screw the third one is the one that got me good the place where you put your hand to close the door look in it the is a cut out section use a flathead to pry that off and underneath it there is the third screw. Once you get all those out just pull starting from one corner and it will snap off.

User Avatar

Wiki User

โˆ™ 2011-08-22 03:23:01
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the car door panel on a 1997 Mitsubishi Diamante?
Write your answer...
Submit
Related questions

How do you set the timing belt on 1992 Mitsubishi Diamante EC 300 v6?

how i can set 1997 Mitsubishi diamante timing beltAnswerhow i can set 1997 Mitsubishi diamante timing belt


Where is your obd plug 97 Mitsubishi diamante?

The 1997 Mitsubishi Diamante OBD 2 port is under driver side dash next to center console


How man quarts of oil for oil change for a 1997 Mitsubishi diamante?

You will need 4 quarts of oil for an oil change for a 1997 Mitsubishi Diamante. Refer to your owner's manual for complete details, recommendations, and instructions.


Why is the TV screen on 1997 Mitsubishi Diamante in Japanese writing?

There is no tv in the 1997 diamanteMaxoutput: there is a tv screen on the diamante as i have one as well...its a touch screen.....because the car is a jap import..i'm still trying to figure it out as well


How do you disable the factory alarm on a 1997 Mitsubishi Diamante?

If you do not have the car's remote.. lock all doors using the diamante key on the driver's side. THen unlock all doors using the key.


Where do you get a wiring diagram for a 1997 Mitsubishi Diamante?

Go to your local library and ask if they have a program called ALLDATA.....look there and I know you will find everything and more that you need to know about the Diamante!! Good luck....


How do you remove the panels off the doors of a 1997 Mitsubishi Colt 1.3L GLX As i could do with adjusting the window levers?

You can remove the panels from the doors of the 1997 Mitsubishi Colt 1.3 GLX by first removing the screws from the door handles. Then, pry the panel away from the frame using a flat tool like a chisel or a screwdriver.


Can you put a 1996 diamante transmission in a 1997 diamante?

no


What does the brake light mean on a 1997 Mitsubishi diamante?

either you have a blown bulb, low brake fluid or you need new brake pads


Need code factory CD player in a 1997 Mitsubishi diamante?

U ether have to take the car to a Mitsubishi dealer and they will charge u like 60 bucks or u can remove the radio and copy the seairl number off the back of it and call mitsubihi and they will give you the 4 digit code


Can you remove the inside driver side door panel to replace the window on a 1997 Saturn SW2?

No. To remove the widow its easiest to remove the outside panel


How do you remove inner door panel on 2006 Chevrolet Malibu?

what steps are required to remove the inside door panel on a 1997 Chevy Malibu.


How do you remove right rear door panel of 1997 Mercedes Benz e420?

In order to remove the rear door panel of 1997 Mercedes Benz e420, you need to drill out the rivets that hold that hold the door panel. Once that is done you should remove the panel in a careful manner so as not to break the plastic clips.Ê


Where is the 1997 Mitsubishi Diamante fuel filter?

It's under the car on the left side, look underneath the car below left rear passenger door. You will find !


How do you remove a passenger door panel on a 1997 Ford Ranger?

remove the window handle, remove screws from armrest, remove the inner door handle and the screw on the lower rear of the door panel, lift the panel upwards to remove from the slots along the bottom of the door.


How do you Replace brake rotors 1997 Mitsubishi montero sport?

Remove the tire and wheel from your 1997 Mitsubishi Montero. Remove the brake shoe assembly. Tap on the rotors to loosen them. The rotors will slide off. Reverse the process to install your new rotors.


Where is the circuit opening relay on a 1997 Toyota Tacoma?

remove the bolts holding on the plastic paneling under the steering wheel in the interior. remove the two bolts connecting the hood release latch from this plastic panel. then remove the panel. the circuit opening relay is under this panel, and is green(in my 1997 tacoma).


Where is the heater fuse panel located on a Mitsubishi mirage 1997?

by left leg under dash. And left engine compartment.


How do you remove the door panel on a 1997 Oldsmobile 88 LS?

try a screwdriver


How do you remove a door panel on a 1997 crown Victoria?

You can see the blueprint of the door on a 1997 Grand Marquis/Crown Victoria at the related link below. This will aid in the removal of the panel.


Where is the turn signal flasher unit on a 1997 Mitsubishi eclipse spyder?

Behind A/C and heater control panel, in center console.


How do you remove the drivers side door panel off a 1997 Nissan Altima?

Carefully


What is the firing order for a 1997 Diamante 3.5L?

123456!!


How do you remove the door panel on a 1997 Monte Carlo?

The 1997 Monte Carlo inside door panel is held in place with two retaining bolts and eight retaining clips. Remove the retaining bolts and pry outward on each retaining clip.


How do you fix a broken dash panel on a 1997 Mitsubishi mirage?

There is no way to answer this question without information on what is broken. "dash panel" can be a piece of plastic trim, or one or more of several electronic gauges.