Need to replace console door/cover and can't figure out how to do this without removing the entire console. Is there another way?
Engine, trans, abs, airbag, cluster, overhead console, information center,Engine, trans, abs, airbag, cluster, overhead console, information center,
how to remove trans shifter cable ball socket from shifter ball
yes, for most repairs
Remove the trans and take it to a transmission repair shop.
Remove the center console (glovebox) and shift surround. Then disconnect the battery. Remove the computer and the computer mounting box. Remove the two rear bolts holding the skeleton in place. Disconnect the cable at the trans. and at the shifter and mark the positions. Carefully raise the rear of the skeleton and pull the cable out the back side of the skeleton then pull it and the rubber grommet from the engine compartment. Install in reverse order.
I think there is no 96 Trans Am. The Trans Sport module is on the rear center of the engine. Remove and replace it with standard US or metric tools. There are three electrical plugs to remove from socket. The Trans am didnt die till 2002 there was one in 96.
A lot more work than it is worth, you will need to change the brake pedal, Remove the clutch pedal, master cylinder and slave, trans mounts may be different, center console, flexplate and torque converter
none, the trans am package came with a console shifter
You are talking about MAJOR repair. Take it to a trans shop.
On the automatic trans, you will have to remove the pan to drain.On the automatic trans, you will have to remove the pan to drain.
You will have to remove the transmission and pull the toqure converter out of the front of the trans. then you will see a seal in the center of the trans. Remove it with a screw driver, then clean and install new seal it will drive in with a hammer if your good. You may need a seal driver.
Usually you unscrew the backing part on the lighter that holds it to the console.