Each cylinder has its own. Remove the covers on the valve covers and you'll find them there.
Very carefully.
remove the coil pack off of the top of the cylinder, remove the spark plug. show me coil pack ?
On a 2004 Lincoln Navigator : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of vehicle
There are 2 coil packs, one on each side of the engine toward the front. Look for the spark plug wires and what they plug into at the front of the engine is the coil pack. Remove wires making note of which goes where; remove wire harness; remove screws holding old pack in place. Reverse order of removal to install new pack.
Mark where the wires go, disconnect the wire connector, remove 4 screws and remove. Reverse the procedure to install.
Here is the number three coil pack located?
remove the plastic engine cover from top of engine, you will have to pull the fuel rail as it runs above the coil packs, remove the screw that holds the coil pack and unplug the harness then pull coil pack and plug wire assembly out.
Remove the air box on the top of the motor that says Vortec 4200. Remove the bolts for the affected coil pack and lift it off. Unclip the connector and replace. For lots more info and help visit our Trailblazer enthusiasts forum at www,trailvoy.com
beneath each individual coil pack. You need to remove a coil pack to get to a spark plug.
(1) Make sure that you have the activation code for the radio. (2) Remove the negative battery cable from the battery. (3) Remove the distributor cap. (4) Remove the screws that secure the wires to the primary terminals and remove them. (5) Remove the two screws holding the coil pack (6) slide the coil pack out. Install new pack and assembly is the reverse of removal.
You remove the 10 mm bolt on the coil pack and unplug the coil. you may have to remove an hold down too to get to #2 or #3 easy to do remove coil by pulling the coil pack setting aside use spark plug socket and a extintion your good
Do you mean this? Left coil pack 1----4 right coil pack 7----8 6----5 3----2