Ford Focus
Ford Ranger
Chevy Camaro RS

How do you remove the cover of the dome light in a 2001 Ford Focus?

404142

Top Answer
User Avatar
Wiki User
Answered
2015-07-15 21:17:52
2015-07-15 21:17:52

Use a small screw driver or somthing that you can use to pry of the lense. Once you have done that you can change the light.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


How do you remove the brake light cover on a ford focus

push down on the top metal cover thingy and pull out, super easy

According to the owner's manual, you pry it off by prying at the front of the cover. Do it carefully

open trunk remove carpet over taillight remove retaning screws

Look in the trunk, there is cover for the brake light, remove and you will have access to change the bulb.

You should remove right defence cover first.

It is very easy to change the license plate bulb in a 2001 Dodge Intrepid. You will need to remove the tag and then unscrew the light cover. After the cover is off, unscrew the light and replace with a new one.

How to Remove the Steering wheel From a Chevy Blazer 2001

on the 2001 XZ3 I removed the license plate and used a flat head screw driver to slid the license plate light cover over and they "pop" out.

Not sure *which* light cover is being asked about, but the "Related Questions" below will cover all 3: headlight, taillight & running light in the front bumper cover

Take Out the battery box, then remove the battery, flip the locking clips on the headlight inside cover, then remove bulb holder twist and bulb can be removed

It just pulls down. There is a tap I just pull on it with my finger. You can use a regular screwdriver to assist. One side has the pull down tab and the other side slips out once it is off.

Just open the engine hood, and look behind either headlight that is out, and remove the cover behind the headlight, should probably be a turning cover, turn cover counter clockwise to remove, then un-plug connection for bulb, and remove light bulb. Light bulb will probably be held in by 2 metal spring clips, that are hooked in, just un-hook springs to remove bulb.

What is the torque level for the valve cover gasket.

I need change the stop light in my Escape 2001 but I don't know remove the cover plastic

Remove the cover from your 2001 Chevy Silverado stereo. Remove the stereo retaining bolts. Remove the wiring harness and the antenna cable from the back of the stereo.

Remove the wiring harness from the high mount brake light. Remove the back cover of the brake light assembly. Take hold of the brake light connector, push in and turn at the same time. Reverse the process to install the new brake light.

because you have an emmissions problem

According to the 2001 Ford Focus Owner Guide : It is below and to the left of the steering wheel , by the brake pedal ( it has a cover on it ) I was looking at one of the drawings in the Owner Guide and the cover might be just to the left of the inside hood release

Remove the decorative cover to your 2001 Chevy Lumina stereo. Remove the stereo retaining screws. Slide the stereo out and remove the wiring harness. Remove the antenna cable.

Disconnect the spark plug wires, disconnect the PCV-valve, remove four nuts holding the cover. Make sure that wires are not in the way. Remove the cover.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.