The 1986 Toyota pickup flasher relay switch is located beneath the dashboard on the drivers side of the passenger compartment. The flasher relay switch will be labeled as such.
The 1986 Ford F1 50 pickup truck dashboard is held in place with six retaining bolts and 10 retaining clips. Remove the retaining bolts and pry outward on the retaining clips.
Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.
The 1986 Toyota Pickup wiring diagram can be found here: http://www.installdr.com/Harnesses/Toyota-Wiring.pdf
Counter clockwise to remove.
In the oil pan
It will fit, obviously the body styles will clash abit, but no biggy
86 toyota pickup steering gearbox problem
are you searching for a particular fuse???
its in the gas tank
No, the frames are different. In 1986 Toyota went from a solid front axle design to independent front suspension. Therefore the frames are different.
Try changing the ball joints
0.32 gap spark plug
3500lbs manual, 2000lbs auto.
under the oil filter
Under the dashboard between the glove compartment and the front heater
Bad synchronizer? Bent shift fork?
made them for a couple of years 86 -88 in pickups and 4 runners
A 1986 Toyota 4x4 uses the same pricipals as a Nissan p/u or pathrinder. Meaning you need to diassemble the hub for the front wheel for the 4x4 once this is done you remove the rotor from the spindle plate and then to the reverse to install should take that long about an hour per side