Chevrolet Cavalier 1995-99 Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (3) 7mm hex-head screws from the top of the glove box liner. Remove (2) 7mm hex-head screws from the top-left corner of the glove box cavity. Remove (1) Phillips screw from the defroster duct. Remove the duct work and (1) Phillips screw exposed. Unclip the dash trim piece and remove (2) Phillips screws exposed. Remove the dash pad and (3) Phillips screws exposed at the top of the radio trim bezel.
Why are ets and engine light on in 98 Chevy cavalier
where is the readlight relay, on the 98 chevy cavalier sedan? thank you.
in the axle
As long as it is the same displacement. Liters/cid. It should
Drum
The 98 Cavalier 2.4 is a NON interference engine.
don't have the foggiest
On my '96 Cavalier, the horn is located in the front driver side wheel well. I had to jack it up, remove the wheel, and then access panel inside the well to get to the horn.
I was able to remove bottom of driver side dash board. Who do you remove to top. Need to fix one bad light bulb.
To change the license plate light on a 1998 Chevy Cavalier, reach up under the bumper and remove the bulb over the license plate. Then put a new bulb in the socket. The bulb can also be accessed by removing the lens on the outside, but there are screws to remove first.
Disconnect the - battery terminal Raise and support vehicle if needed Disconnect the wiring harness at the top of the starter Remove starter mounting bolts Remove starter
In the back by the coil pack.