To remove and replace the heater core on the 1987 Nissan 300ZX with air, begin by removing the dashboard totally. This means the radio panel and the instrument cluster. Remove all air ducts and access the heater core. Remove the bolts holding the core and replace it with a new core. Then replace the dashboard and instrument panel.
To remove the dashboard and replace the bulb on a 51 Plate Clio, first remove the two screws on the trim panel. Then remove the instrument cluster and gently pull off the bulb. Replace with new.?æ?æ
You have to remove door panel
How to remove left inner door panel of a Pontiac Bonneville 1996
You will need to remove the dashboard panel in order to replace the electronic throttle control light. With the dashboard panel removed the light can be access to be replaced.
remove the top trim panel off the dashboard, the front trim panel from the instrument panel and remove the screws. good luck finding a replacement cluster
To replace the dashboard lights on the 1997 F-150, you will first need to remove the dash bezel and dash cover in order to access the lights. Then, remove the instrument panel cover below the bezel and remove the burned out lights. Replace the lights and add the cover, dash cover, and bezel back to the dashboard.
If all of the dashboard lights do not work at the same time on a Pontiac Montana, check the instrument panel relay. The relay is located on the firewall in the engine compartment.
the panel around the stereo pops off. You can do it by hand or use a flat head screwdriver.
instrument panel or controls?
just remove it
Remove the panel under steering wheel. There will be 2 flashers. Replace one on right.
how to remove the vent from dashboard of 1996 ford contour
You need to remove the door panel to access the bolts and electrical for the mirror. To remove the door panel, it is all clips on the outside however there are 2 hidden bolts that you need to remove the cover from the door pull to access.
cant open tailgate
Using a screwdriver, remove all the screws in the door panel and remove all the clips holding the panel to the frame. Gently pull the panel away from the frame, remove an wire connectors and pull the panel off the frame.
Remove door panel, remove 4 screws, remove speaker, put new speaker in, replace screws, replace door panel. Done.
the panel just snaps off
The dashboard lights on a 1997 Eagle Talon can be changed by reaching up into the dash to get to the bulbs. Another way is to remove the dashboard screws and remove the front of the instrument panel.
On the passenger side under the dashboard, first remove the fire panel and unclip the light. The resistor is towards the far back in the center. There are some screws that are kinda hard to get to, but it is possible. Unclip the wires on the old resistor and remove the screws and remove the resistor. Then place the new resistor where the old one was removed from and replace the screws, attach the wires. Now re-attach the light to the fire panel and replace the panel.
You will need to remove the inside door panel in order to replace the side mirror. With the door panel removed you will find the side mirror is held in place by two retaining bolts. Remove the retaining bolts. Reverse the process to install the new side mirror.
Depends on the year; my 89 dash panel comes out with screws and the bulbs are twisted in to the backside of the panel. :]
Remove center stack bezel (radio, heater control), remove screws from instrument trim panel at ctr stack and remove instrument trim panel, remove dash top panel, replace speakers.
How can I take apart the dashboard of a 1995 gmc Yukon
remove the door panel screws and pull up on the door panel to correctly remove it. then remove the 3 bolts on the upper corner and unplug and replace