0
How do you remove the dashboard to replace the stereo in a 1999 sebring LXI coupe?
Wiki User
∙ 12y ago
the panel around the stereo pops off. You can do it by hand or use a flat head screwdriver.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you remove the stereo in a 1988 Toyota Corolla?
It a simple task to remove and replace your car stereo in corolla, you start by gently pulling out the chromes which surround the tape and eventually u came find the screws that is used in holding the stereo to the dashboard This will help remove and replace with an Android car play You can watch this video for more understanding @dekingsdesign493 in YouTube
How do you replace radio on a villager?
To replace the radio on the Villager, first remove the bezel from around the radio by prying it from the dashboard. Then, squeeze the clips on either side of the radio to remove it from the dash. Disconnect the wires and attach them to your new stereo. Then, replace the clips and the bezel.
How do you change car sterieos?
To change car stereos, you will need to remove the bezel or cover from the stereo in the vehicle. Then, pull the stereo out of the dashboard and remove the wiring harness. You can then attach the new stereo to the harness.
How do you replace stereo in vy?
Begin by removing the decorative cover to your stereo. Remove the stereo retaining screws. Slide the stereo out and remove the wiring harness. Reverse the process to install your new stereo.
How do you remove instrument cluster on 98 Ford Ranger to replace cluster bulb?
DIMMER SWITCH OR WHAT?"How_do_you_remove_instrument_cluster_on_98_Ford_Ranger_to_replace_cluster_bulb"My 1995 Ford Ranger dashboard is dark, the control to the cab light is operational. I have installed a JVC Stereo with is the only light I have on the dashboard. Do I need to remove the steering wheel to get to the components of concern?
How do you install a stereo deck in 95 Jeep Cherokee?
remove the dashboard face then you should beable to remove and put in your new stereo u may have to take out the heater cointroll unit to get do that
My radio only works when the headlights are on in your 99 Chrysler sebring JXI does anyone know what could be causing this?
If it is an aftermarket stereo then i would say that the installer tied into the dashboard illumination or headlight power wire for 12 volt power for the stereo.
How do you replace stereo Renault modus?
You can use a very small screwdriver to remove the stereo and replace it with the new one, or you can purchase special removal tools.
How do you remove the dashboard in a 92 Honda Accord to install a stereo?
remove the cup holder and ashtray assemly ther are two small screws facing upwards remove them and it will come out There're more! Unplug the light of the trash tray, remove tray. Loosen two upward BOLTs at the back. Draw the stereo partially, then fully remove the bolts with hand. Afterwards, remove the stereo.
How do you remove stereo from 1987 accord?
* Remove the ashtray and ashtray holder * Remove the mounting screws lower the radio unplug the electrical connector and antenna lead then pull the radio out of dashboard
How do you remove a stereo from 1988 mercedes280e?
you must first take a screwdriver and pry off the dashboard. Then take the back end of a hammer, and remove the radio, while cutting through all the back wires. Put the dashboard back on, and your done!
How do you remove a car stereo?
You can easily remove your old car stereo without taking help of a car stereo expert. However, you need to follow some steps and need some tools to remove your old car stereo. You can save your money by following the steps for removing your car stereo otherwise you have to pay more money to the professional car stereo installer.Here are some steps to remove the car stereo safely.First of all, Read the user manual of the car where you can find some tips to remove the car stereo. You may find a diagram of stereo wiring, so it would be more help to you.To remove your car stereo safely, please disconnect the battery to avoid electrical short during working with wires of car stereo.To remove your car stereo from the dashboard use screwdrivers to remove the screw, which is holding car stereo. Furthermore, check that your car stereo connected with dashboard using spring or clips and others.Remove dash panels and take out the bolts and screw which hold car stereo. Now pull out your car stereo.Now you can see there are some wires, which are connected on the back of the car stereo. A wiring of car stereo is protected with clip. You should pull out the wire straight out.For more information about remove old car stereo and want to new car stereo installation, please feel free to visit this blog Houstoncarstereo.com/blog/
