Electric Windows
Chevy Blazer
Chevy Cavalier Z24
1995-2005 Chevy Cavaliers

How do you remove the door panel on a 1999 Chevy Blazer The drivers side power window does not work the passenger side does you have power coming out of the switch so you need to check the motor now?

141516

Top Answer
User Avatar
Wiki User
2005-10-19 05:32:32
2005-10-19 05:32:32

Another place you can check is the wires in between the door and front panel sometimes the wire will break from the opening and closeing the door. also check to see if you have power to the switch with a tester.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The heater core is located on the passenger side, not the drivers side. You do not have to remove the steering column or any parts around it.

User Avatar

The 2000 Chevrolet Blazer passenger side kick panel is held in place by eight retaining bolts. Remove the retaining bolts and the kick panel will come free.

User Avatar

Assuming this is a 4.3 engine, remove the block coolant drain plugs. There is one on each side of the block. The passenger side is towards the front of the block and the drivers side is towards the back.

User Avatar

remove the passenger pad first, when removed it uncovers screws on the rear of the drivers seat. Remove these and it comes off.

User Avatar

To remove the passenger side airbag on a 2003 Blazer, look inside the glove box for the bolts that must be undone, take these bolts out. You will also have to disconnect the vehicle's battery, and disconnect the wiring that goes to the airbag from underneath the dashboard. You will have to remove the front speaker and use a socket to remove the one screw that you see. The other screw can be found by removing the dashboard.

User Avatar

how do you remove the dashboard of a 2002 Chevy blazer

User Avatar

remove passenger front tire then fold back the water guard then you will access to the starter

User Avatar

on a 1997 blazer, how to remove drivers side mirror under your handle to close the door is two 7mm bolt and behind your handle to open the door is a Philips screw and that plate behind it comes off then CAREFULLY remove the door panel trust me you don't want to break the plastic then you will see your mirror bolts and electrical wiring

User Avatar

For step by step instrustions with picts go to . http://www.a1electric.com/s10motor.htm

User Avatar

Inside the transmission. Remove transmission pan and towards the rear of the transmission there are 2 solenoids.The one on drivers side of vehicle is for 1st to second gear shifting. The one on passenger side is for 2nd to 3rd gear shifting.

User Avatar

its under the drivers side of the dash you may have to remove a plastic kick panel just below the dash

User Avatar

how to I remove the overhead console on the S 10 Blazer?

User Avatar

You need a torx bit 40 or 45 I think. Ok, follow the seatbelt up to where it

User Avatar

How to Remove the Steering wheel From a Chevy Blazer 2001

User Avatar

The 2001 Chevy S 10 Blazer power door lock relay switch is located inside of the drivers side door. You will need to remove the drivers side door panel in order to access the door lock relay switch.

User Avatar

Passenger mirror access is same as drivers side. Three screws accessible inside door panel to remove entire mirror assembly. To remove mirror within the mirror assembly it just pulls off - snap fit of mirror mount to drive.

User Avatar

how do you replace a drivers side mirror on a el ford falcon

User Avatar

Passenger side go in from under the hood and find the socket. Remove it and replace the bulb. Drivers side is a different story. You have to remove the battery to get at the socket.

User Avatar

if it is not on the drivers side of the engine, there may be a stock oil filter relocator that puts the oil filter right behind the drivers side headlight, you must remove the air filter box to see it.

User Avatar

remove dashplate then unbolt radio

User Avatar

remove passenger seat in 2003 cadillac cts

User Avatar

Under the passenger side, behind the glove box, attatched with velcro. Remove 3X, 5/16 screws to access it by passenger feet. About 2inch by 3inch circuit board inside the module compartment which pulls out.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.