0
How do you remove the door panel from a 1997 Dodge 1500 pickup truck to fix a window?
Wiki User
∙ 17y ago
there are various screws on the door panel some are hidden, being these are the new age cars i would search for the screws if i think i have them all i would start at the bottom edge and pop the edges first then give a slight tug up on the panel to release it from the edge lip on top where it hangs on by the window once that s done try pulling outward not to hard just to make sure all screws are free.once you inter the panel the window should be visable on a track held by two ten millameter bolts.reverse proceeder job well done.
Wiki User
∙ 8y ago
Wiki User
∙ 18y agoYou must release dont take off rear view side mirror remove small panel you will see 3 nuts release them, you will find screws around inside panel take them all out the outside door handle has plastic keepers under the handle push center plastic keeper out with scracth all them remove larger outside keeper with needle nose pliers or sharp knife. remove window trim on edge of door lip. with window down if you can get it down pull panel out from bottom and then up be patient it will come off. rver10@sbcglobal if you have more questions
Wiki User
∙ 17y agoRemove the 2 screws in the little tray for the panel and the screw up by the mirror. Then you can use a flat head screwdriver or buy a prior. There are little rivets along the panel in the back. A new box of rivets is like 3 dollars. Becareful when pulling it off as it can break the mounts...just work each rivet one by one and it will pop off easily.
Wiki User
∙ 16y agoRemove bezel around inside door handle and screw if so equipped.
Remove 2 bolts near armrest.
Push upwards.
Pull away from door.
Give me a recommendation.
Wiki User
∙ 9y agoThe 1997 Monte Carlo inside door panel is held in place with two retaining bolts and eight retaining clips. Remove the retaining bolts and pry outward on each retaining clip.
Wiki User
∙ 14y agoremove the screw in the arm rest another one in the corner at the bottom. and then pull up from the bottom of the panel it will lift off it has hooks that fit into square holes.
Add your answer:
Earn +20 pts
How do you install a driver side power window on a 1997 Dodge Dakota?
remove door panel, install new window
How do you change window regulator 2005 dodge stratus?
To remove the window regulator in your 2005 Dodge Stratus, you would need to remove the door panel, and then the water shield behind the door panel. Tape the window into the up position with tape, and then you can access all of the nuts and bolts to remove the window regulator. I have included a link below to an instuctional video that will show you how to do this on a 01-06 Dodge Stratus.
2003 Dodge Caravan power window motor replacement?
how to replace power window motor for 2003 dodge grand caravan? how to remove side panel dodge caravan 2003?
How does one replace the cab window beltline on a 1995 Dodge 2500 pickup?
Remove the inside door panel. Loosen the tensioner pulley. The belt line will become loose and can be removed. Reverse the process to install the new belt line.
How do you remove the door panel for a 2004 dodge ram?
You have to remove all of the Phillips screws,the door handle and the master power window switches. Then tug up on the door panel and it will life right off.
How do you repair a drivers side power window of a 2001 dodge caravan which has fallen into the door?
Remove the inside door panel. The entire power window mechanism will be visible. Put the window back onto the window track.
How do you change a manual window regulator on a 2001 dodge pick up truck?
Hello, this is straigh from the dodge repair manual. If you need pictures let me know John Roll window down. Remove window crank, if equipped. Remove screw attaching trim panel to outside mirror frame. Remove screws attaching pull cup to door. Using a trim panel removal tool, disengage clips around perimeter of trim panel, attaching trim panel to door. While holding bottom of trim panel away from door, simultaneously lift upward and inboard. Disengage power mirror switch connector, if equipped. Disengage power window/lock switch connectors from switch panel, if equipped. Separate trim panel from door. Remove door trim panel . Peel waterdam away from adhesive around perimeter of inner door panel Remove the door waterdam . Remove nuts attaching door glass to window regulator. Remove glass from door or move glass to full up position and secure glass to door with tape. Disengage power window motor wire connector from door harness, if equipped. Remove bolts attaching window regulator to inner door panel. Separate window regulator from door panel. Extract window regulator through access hole in inner door panel.
How do you remove window handle on a 1986 Mazda pickup?
there is a small clip between the handle and door panel that u have to remove it is easy if u have a small pick to hook it with then to install just place clip on handle and push on the window regulator shaft.
How do you replace drivers side window motor in a 02 silverado pickup?
Remove the door panel and unclipped the three plastic retaining tabs that hold the window motor in place disconnect wire connector and it's out
How do you replace power window switch 2004 dodge stratus?
To replace the window switch in your 2004 Dodge Intrepid you need to remove the door panel. Once the door panel is removed there are two T-20 Torx screws that hold the switch to the door panel. I have included a step by step auto repair video below, that shows how to accomplish this.
How do you remove the drivers side door panel on a 2004 extended cab XLT Ford Ranger pickup?
I have a drivers side (front) speaker that went out. I think the problem is a speaker connection. How do I remove the window crank (not power windows) and then the whole inside panel?
How do you remove an explorer back side door panel to see why window will not hold up?
You must remove door panel and replace window regulator.
