0
How do you remove the driver's airbag on a 2002 S-10 and how many bolts hold the wheel to the steering column?
Wiki User
∙ 17y ago
Pull the Air bag fuse, remove lower kick panel, disconnect the Yellow connector, Three or four bolts hold the bag to the wheel, another yellow connector, horn wire, then a clip and a 21 mm headed nut. Then you need a steering wheel puller to remove the wheel
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you remove a steering wheel from a 1994 Mitsubishi 3000 gt?
To remove the steering wheel start by disconnecting the negative battery terminal to prevent accidental airbag deployment. Then remove the screws on the backside of the steering wheel to remove the airbag. Disconnect the airbag wiring connectors. Remove the steering column shaft nut and remove the steering wheel with a puller. Do not yank, hammer, pry the steering wheel off as this could result in steering shaft damage.
How do you remove the steering lock on a 1994 Ford Probe?
# Disable airbag system. # Remove steering column covers and lower instrument panel cover # Lower steering column # Disconnect the shift interlock cable from ignition lock housing # The lock assembly is clamped to the steering column by two shear-head bolts. Drill heads off each bolt and remove the bracket. # Remove the steering lock assembly from the steering column
What is Code 32 for airbags in a 1997 Mercury Cougar?
It is an open circuit in the drivers airbag. There is a clockspring behind the steering wheel that may be worn. To replace, remove airbag, steering wheel, column covers, and lower dash cover. MAKE SURE WHEELS ARE STRAIGHT. The new clockspring comes centered with a yellow locking tab. Remove that after installing it.
How do you remove the airbag on a 1995 Ford Escort wagon 1.9 in order to replace the gas gauge light?
You shouldn't have to remove the airbag in order to replace the gas gauge light. The steering column is held up by a couple of retaining bolts. Remove these bolts and the steering column will lower enough that instrument panel will come out easier. The steering column won't drop to the floor when you do this but will hang in midair. If you have a tilt wheel, you might have to adjust the wheel tilt to allow the panel to come out easier. Don't forget to remove the steering column cover though.
How do you remove 1999 holden commadore drivers airbag steering wheel?
To remove the driver's steering wheel airbag on a 1999 Holden Commodore you will need a special set of tools to remove the 4 to 6 security screws that are holding it in. If the vehicle came equipped with a airbag, it needs to have one to remain road safe.
Where is turn signal switch on 98 explorer?
In the steering column. You'll have to remove the steering wheel with a steering wheel puller tool. This can be a dangerous repair job due to the airbag in the steering wheel. Get a Haynes or Chilton's manual for the details on how to do this as well as how to disarm the airbag system.
Does replacing the steering column fixthe airbag?
No, the airbag system, and the steering system are completely different. The airbag, in the centre of the steering wheel (i assume) can be replaced. Lets say for example, your vehicle has a crash, and the airbag is deployed, you will need to replace it, and then remove any fault codes from the airbag module (or ECU). If the airbag light is illuminated, but the airbag hasn't deployed, this indicates a general fault (which shouldnt be ignored) Personally id have this investigated by a trained technician, as an exploding airbag isn't something i'd like to be standing next to! SRS systems are complex and rely on a control module, its more electric than it is mechanical, replacing a steering column would just simply; replace the steering column...
Remove steering column 1995 ford van?
Disconnect battery. Wait 10 minutes, then remove airbag module (if equipped) and horn pad. Remove steering wheel. Pull off plastic trim panel below steering column. Turn ignition key to run (not start) and press lock tang to remove lock cylinder. Remove steering column lower shroud. Remove steering column upper shroud. Remove multi-function (turn signal/wiper/hazard) switch. Remove metal 'knee brace' bracket below steering column. Disconnect all affected wiring including wiring to ignition switch. Remove pinch bolt at bottom of steering column. Remove 2 nuts and t bolts mounting steering column. Note that it will now drop down and may pinch fingers or toes. Remove column from vehicle.
When replacing the heater core on a 1998 Blazer is it necessary to remove the entire steering column surrounding components?
The heater core is located on the passenger side, not the drivers side. You do not have to remove the steering column or any parts around it.
How do you disarm the airbag on a 94 camaro and remove the steering wheel?
simply pull tha airbag fuse. remove the 4 torx head scres behind the airbag and remove airbag. unplug theelectrical connector. remove the big nut holding the steering whell. use a puller to remove the steering wheel.
How do you remove the steering column shrouds on a 2003 Bonneville?
I'm not sure but I think you are going to have to pull of the steering wheel to get these off. That means removing the horn button and the airbag first.
How do you remove Nissan primera drivers airbag?
Take off the steering wheel cover and unscrew all the screws then disconnect the wires.
