Procedure as covered in the Haynes repair manual, did't answer all of my questions either however, since I have just accomplished this task this is how it goes.
Tools required: Small jewelers screwdrive flat blade, #2 Phillips screwdrive 6", 3/16" flat blade scredriver 6" and, flashlight.
Retract window to full down position, Remove all screw covers with jewerlers screw driver; Small round flush mounting plug in center of plastic triangle above door panel, behind door latch single cover, cover in center of door pull, and lower front of door panel single cover. Use #2 Phillips screwdriver and remove parimeter screws located on sides and bottom of door panel (use flashlight if needed), from center of pastic triangle (shorter of four larger screws), screw from door panel lower inside which was covered, two screws from door pull area, and single beveled screw located behind door latch. Using 3/16" flat screwdriver, this is a little tricky, remove plastic cover from around door latch/window/lock controls area, front is clipped in and can be gently pried out, and at the same time there is another plastic piece which needd to be pushed in with tip of screwdriver to release its beveled hook from latching piece to door. This plastic latching device is behind door opening latch and is difficult to see, or at least recognize how to release it from its position. Once the center plastic piece is remove than the entire door panel can be lifted from the door. Good luck
In the drivers footwell , behind the kick panel ( there is an access hole in the kick panel )
This is not the Ford Contour page this is the Escort Page. ========================================================= On a 1998 Ford Contour : The fuel pump shut off switch ( inertia switch ) is located in the drivers footwell behind the kick panel ( there is an access hole ) * the kick panel is the interior trim panel , in front of the front door , beside the drivers left foot
Yes , in the drivers footwell , behind the kick panel ( there is an access hole )
Usually located behind the driver's door panel. Remove inside door panel for access
On a 1998 Ford Contour : The fuel pump shut off switch ( inertia switch ) is located in the drivers footwell behind the kick panel . There is an access hole through the panel ( it's near the inside hood release )
The 1998 Honda Civic drivers side door panel is held on by eight retaining clips. Pry outward on each retaining clip to remove the door panel.
The drivers side kick panel is in the drivers footwell , just ahead of the drivers door It is an interior trim panel by the drivers left foot
Door Panels Removal & Installation 1. Remove the sail panel. 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. 4. The installation is the reverse of the removal.
On a 1998 Ford Ranger : Open the drivers door and in the drivers end of the dash you will see the removable plastic fuse panel cover
In a 1998 Ford Contour : In the passenger compartment fuse panel : ( # 24 is a 15 amp , light blue color fuse , for the brake lamps )
According to the 1998 Ford Contour Owner Guide : In the passenger compartment fuse panel , below the instrument panel : ( # 28 is a light green color 30 amp fuse for the electric seats )
The relay panel is located under the dash board, above the drivers feet, remove the lower cover panel to access relay box.
next to the ecu, drivers side remove interior sill plastic trim and kick panel
The 1998 VW Jetta drivers side power window relay switch can be found inside of the drivers side door. You will need to remove the drivers side door panel in order to access the power window relay switch.
the dipstick for the tranmission is on the drivers side in the back of motor.
on the downward frame tube just above above the drivers foot position,you may have to remove a panel to see it
First and formost, what engine? i4 for a v6?
Remove the door panel
drivers side under dash near door
The 1998 Ford Explore power window relay switch can be found in the drivers side door. You will need to remove the door panel in order to access the switch.
In the drivers footwell , behind the kick panel . There is an access hole in the panel
I HAVE SAME PROBLEM. WHAT DO YOU DO? email@example.com THANKS, BJ
Check the drivers manual, it will show you what fuses are for what.
( # 17 ) is a 25 amp fuse for the cigarette lighter in your 1998 Ford Explorer ( in the fuse panel in the drivers end of the dash , the fuse panel cover is visible with the drivers door open )
it is the plastic panel to the left of your feet on the drivers side and to right side of your feet on the passengerside.