It is held in place by two screws, remove them, pull the handle towards you and that should do it.
With a hammer and pry bar.
To remove the 2002 Hyundai accent rear seats find the tabs that cover the bolts and unbolt them. After the bolts are out lift the seat to remove it from the car.
Make your life easy and just break off the door handle. When you are finished with your project, just replace the door handle with a new one from the dealer.
Yes they are; and they are a pain to remove.
remove the dash board panel around it and take it out
Break it off or remove with large wire cutters
A door panel on a 2005 Hyundai Accent is mounted with screws and clips. Loosen all the mounting screws. Pull the panel outward and pop out the clips. Remove the door panel.
I had my 95 Accent handle break. I had to take the inner door panel off. There is a 'c' clip on the inside of the lock for the door. Remove it. There are 2 nuts holding the handle in place. It is very awkward to do. Just don't lose the 'c' clip. It is small.
a scewdriver or hammer
Remove the 2 screws and take off the plastic piece.
The front driver side quarter panel on a 2002 Hyundai Accent is mounted with several bolts. Lift the hood and loosen the bolts in the engine bay. Loosen the bolts in the wheel weld, door hinge and to the bumper. Pull and remove the panel outward.
http://www.hyundaiforum.com/forum/showthread.php?t=6830
ta ke the front doors off, they are screwed into the door fame! I have a 2000 Hyundai Accent and recently replaced my entire streo system.
I had the same problem with a Hyundai Accent 1996. You need to disconnect the speedometer inside the front hood.
Get a manual on your car and do the job right the first time.
The interior door handle on a Hyundai latches onto the locking mechanism of the door. First remove the old handle by unscrewing it from the door panel. Pull the handle out and remove the locking wire. Install the new unit with the locking mechanism in place. Tighten the mounting screw.
I'm presuming you mean the actual handle you grab. If that's the case, the handle slides over the crank shaft and a "C" shaped spring (actually, it looks just like the Ohm symbol Ω or capital greek letter omega) locks into a notch in the shaft through holes in the handle. What you need to do is remove this spring and then the handle will just pull right off. Something I've found to work is sliding a towel between the handle and the door. It will catch on the points of the spring "Ω" and pull it right off!
The starter on a 1995 Hyundai Accent is mounted directly to the transmission. To find it trace the positive battery cable. Remove the two bolts that mount it to the transmission and unplug the wiring. Replace the unit.
You will need a 5/8 socket.
* To remove the outside door handle and lock assembly raise the window and remove the door trim panel and watershield * Working through the access hole disengage the plastic clips that secure the outside handle to latch actuating rod and the outside door lock to latch actuating rod * Working through the access hole remove the outside door handle retaining bolts * Remove the handle/lock cylinder assembly from the car
Why you would want to does this is a mystery. If you insist, remove the bulbs.
It is located under the rear seat. To access you must first remove the cover.
You'll need a 5/8" socket.
where is the ecu for a 2002 Hyundai Accent?: this computer is located under the dash, left side. can't miss it, just look under the dash. bolted in with 6mm bolts, use 10mm socket to remove. Make sure you disconnect battery first if you decide to remove it or replace it.!
To changeÊthe ignition switch on a Hyundai Accent, first, one should remove the switch from the steering column, to which it is attached. From there, the component can be replaced.