answersLogoWhite

0


Best Answer
Copy

To remove the engine cover you have to twist the base of the oil reservoir and it should pop up and off lift up the engine cover the the back end of the cover is held down by a position point or pressure from the front being secured that when you undo the front lift it up and it should just slide right out. Eric

User Avatar

Wiki User

โˆ™ 2011-10-20 16:57:01
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you remove the engine cover on 1999 grand prix?
Write your answer...
Submit

Related Questions

How do you remove a engine in a 1999 Pontiac grand prix 3.8L?

how to remove a engine in a 1999 Pontiac grand prix 3.8L


How do you remove headlight cover on 1999 Pontiac grand am?

What do you mean by headlight cover?What are you trying to do?JW


How do you remove oil pan on 1999 Saturn sl?

You must remove the Timing chain cover and engine girdle.


How do you remove door speakers from 99 grand am?

The 1999 Pontiac Grand Am speakers can be removed by removing the speaker cover. The speaker cover is held in place with two screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.


Where do you add oil in a 1999 Jeep Grand Cherokee 4.0l engine?

Through the cap in the middle of the valve cover.


How do you tell how many teeth are on the cam on a 1999 grand Cherokee 4.7 liter engine?

You have to take the valve cover off and count.


Where is the PCV valve on a 1999 grand caravan 3.3litre?

Under hood, center, upper engine area, mounted in front valve cover


How do you change 1999 grand am gt v6 spark pluGS that are in the back?

Remove the top motor mounts and tip the engine foreward


How do you remove the engine cover on a 1999 Olds Intrigue?

Easy as pie. Remove the 2 black nuts at the front of the cover. Pull up the front edge and swivel the rear edge out of the clip that holds it down.


Can you replace the rod bearings in a 1999 Pontiac grand am without pulling the engine?

Yes..you should be able to. You'll have to take off the starter, remove the front engine mount to be able to lift the engine slightly then remove the oil pan.


Where is the engine temperature sensor on a 1999 Toyota Tacoma V6?

It is located at the front of the engine below the top radiator hose you have to remove the top timing belt cover to get to it.


How do you remove the front plastic bumper cover of a 1999 Jeep Grand Cherokee Laredo to access metal bumper?

I do not believe there is a metal bumper. There is a foam insert that goes inside the bumper cover.


Why does coolant leak when the engine is off on 99 grand am?

why does the coolant only leak when engine is off on my 1999 grand am?


How do you remove the engine from a 1999 Taurus?

you can remove the engine from the top by leaving transmission still in car


Is the 3.3 engine on a 1999 dodge grand caravan sport an interference engine?

No.


How do you access the distributor cap on a 1999 Astro?

You have to remove the Engine Cover inside the Van. Two Larger Screws fasten the Engine Cover to the Firewall, near top of each side. Two Bolts Clamp the cover to the floor. You also have to remove the glove box storage unit. Two small screws and two nuts.


Where is the crank position sensor on a 1999 Chevrolet Malibu?

The 1999 Chevrolet Alamo crank shaft position sensor is located on the back of the engine. You will need to remove the rear engine cover in order to access the crank position sensor.


Where is the air filter on a 1999 Dodge ram3500 van?

On top of the engine block. You'll need to remove that engine cover inside the van to get at it. It's in the big round cleaner assembly.


Installing drive belt for 1999 Kawasaki Prairie 400 4X4?

To install drive belt on a 1999 Kawasaki Prairie 400 4x4, access the engine area and remove the cover that holds the clutch. Remove the drive belt around the clutch at the right side of the engine. Replace with new.


How do you install a front valve cover gasket on a 1999 Pontiac Grand Prix?

For the 3.8L supercharged this is what needs to be done. Remove the front lift bracket, the front dog bones , the passenger side engine coil bracket(it has the coils on it), remove the spark plug wires , remove the 6 valve cover bolts and pull the valve cover. When reassmebling use a torque wrench so as not to overtighten. (torque to about 89 inch lbs I think) Hope this helps. "G"


Where is the water-pump located on a 1999 Grand am SE 2.4L?

its driven off timing chain. You have to remove the large timing chain cover to access it, requires good mechanical knowledge, easy to damage engine on these quad fours if not done right.


Where is the engine control unit located on a 1999 Pontiac grand am 4 cylinder engine?

It is on the right side of the engine cover where your spark plug boots attach to the coil packs. It's that little metal box the connector goes into.


Where is the thermostat located on a 1999 2.4 liter Grand Am?

The thermostat on a 1999 2,4 liter Grand Am is located on the side of the engine. The thermostat is on the drivers side of the engine a few inches from the top.Ê


How do you remove the dome light cover on a 1999 Toyota Avalon?

It


Where is the ignition coil located on 1999 Chevy astro van?

On top of the RH Side of the Engine. You will need to remove the engine cover from the inside of the van to get to it. Just trace the coil wire from the distributor.