There is no evaporator on that model.
The evaporator on the Ford Mustang is located between the dash and the firewall. Dash removal is required to remove the evaporator for replacement. The dealer replacement evaporator comes with the evaporator housing. The intake air assembly, blower motor, blower resistor, actuators, heater core, etc., have to be switched to the replacement housing. There is a photo on Honda Man's Bio page with the dash removed and the evaporator housing placed on the rear of the car.
You can swap a 1997 Mustang V6 into a 1968 Mustang. You will need to make several modifications to the 1968 Mustang.
From under the hood, recover the refrigerant and disconnect battery, remove the drier, two ac line connections to evaporator core, two heater hoses from heater core, vacuum line that goes to firewall and evaporator case nuts at firewall. From the inside of the car, remove center console, center the steering wheel, lock steering and remove steering column assembly. Remove pillar trim, kick panels, defrost trim, remove bolts along the top and sides of dash, disconnect any vacuum lines that go from the ac controls to the evaporator case, unplug any electrical connectors that prevent the right side of the dash from being swung over to allow access of the evaporator case. Use a tie down strap to secure the dash out of the way if needed while accessing the evaporator case. There is a picture of a Mustang with the dash removed at DenLorsTools.com in the Tech Artice How To section. Remove the evaporator case from the vehicle and replace the evaporator, put two ounces of refigerant oil directly into the replacement evaporator. Reverse removal procedures, evacuate and recharge system.
Before you remove the evaporator core from a 1998 Pontiac Bonneville you need to have the air pressure discharged. You will then need to remove the AC unit. You will need to remove some screws before you can remove the evaporator.
Nick Jonas' Mustang is a 1968 Ford Cobra Mustang
If it's for the front evaporator the box is underneath the dash board. You have to completely remove the dashboard in order to remove the evaporator case on a 1996 Town & Country.
The 1968 Ford Mustang 6 cylinder produced 195 horsepower ========================================================= In a 1968 Ford Mustang , the 200 cubic inch inline ( straight ) 6 cylinder engine was rated at ( 120 horsepower )
The Evaporator is the part of a refrigeration system that absorbs heat. Its counterpart is the condenser which is used to remove heat that was absorbed in the evaporator.
remove all the screws
remove glove box. disconnect harnesses and remove evaporator and thermostat is behind it. remove glove box. disconnect harnesses and remove evaporator and thermostat is behind it.
The last year a Mustang Fastback was made was 1968.
On a 1968 Ford Mustang 200 cubic inch straight 6 cylinder engine the points are gapped at ( .027 )