You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
- I actually just replaced mine last year on a 2.4l. If you aren't mechanically inclined you will want to take it to a garage. It is realatively hard. First you have to put the car up on ramps and slid back to the firewall. You have to remove the 3 10mm bolts on the heat sheild. you can then remove the lower bolts to the down pipe. the upper bolts you have to use a combination of under the car and under the hood. i had to remove part of my intake to get to the bolts. if you thought that was hard its even harder to remove the actual manifold. you have to have it sidewaysand twist it around alot to get it out. it took me the better half of two days to change it out but it was better than paying $600 dollars to get it done.
the side of the motor close to the firewall
In the exhaust pipe, near the manifold. The 4 cylinder has 2, the V6 has 4.
Call your local wrecking yard. They have interchange manuals and software. yes it will sohc and dohc. not sure they will Stratus has the exhaust manifold in front, neon in the rear
In the exhaust manifold on the back of the engine.In the exhaust manifold on the back of the engine.
Look on your exhaust manifold on the back side of the engine for a tube running to a valve with a sensor and vacuum line
The starter for a 2005 dodge stratus is mounted on the side of the engine. It is over the exhaust system.
usually, upstream means the one in the exhaust manifold and downstream is the one closest to the catalytic converter
Back side of the engine, below the exhaust manifold. It is protected by a silver heat shieldBack side of the engine, below the exhaust manifold. It is protected by a silver heat shield
where is the manifold located on the 2004 dodge stratus 2.7l
Driver side exhaust manifold.Driver side exhaust manifold.
No. They are in the exhaust pipe.