You must first remove the wood grain that hides all the screws, use a screw driver or puddy knife to do that. Then remove all of the screws related. It's about 14 (+/-). You'll need a Phillips and a 10mm socket. Alot of the front dash will come off but you are doing it correctly. Then disconnect the wiring harness. Good luck.
Remove the 2002 Dodge Durango factory stereo decorative cover. Remove the factory stereo retaining screws. Pull the factory stereo out. Remove the wiring harness and the antenna cable from the back of the stereo.
To remove the factory stereo on 1996 dodge ram 1500 you need to pop the hood on the Ram and remove the ashtray. Slide the stereo out of the dash and unplug the cables from the back of the stereo.
open your cup holder and on the top lip of opening there will be two screws, remove those then the center dash piece can just be popped off. then theres just four screws holding in the factory stereo.
What do you mean how do you get it to work did it break?
back deck speakers are 6" x 9" door are 6 1/4 " and dash are 3 1/2 "
There is a factory recall on the stereo system. Take it to a Dodge dealership.
There are a few screws in the dashboard and some clips holding the dash in place. Take those out and just pull the dash off. Then the stereo is screwed in to the frame. Unscrew it, unplug it, and you're good to go.
There is an amp only if equiped with factory infinity stereo with 7 speakers. If so, the amp is behind the glovebox.
Which pulley are you referring to. There is 5 or 6 on that car.
I need help removing my dash to get to the back of my stereo on my 2006 dodge ram 1500
you can't, it is built into the body computer
YOU CAN GET A WIRING KIT THAT PLUGS STRAIGHT INTO THE FACTORY HARNESS AT A STEREO SHOP OR WAL-MART FOR ABOUT $15. COMES WITH DIRECTIONS AND PICTURES. HOPE IT HELPS
Call an egineerer haha or remove the plastic cover around the stereo and the screws are easily accessible and if you don't want your stereo email me at firstname.lastname@example.org thanks
It looks like a1989 dodge dynasty! Go to your browser search, and type in pictures of 1989 Dodge dynasty and you will see what a 1989 Dodge dynasty looks like.
ITs Behind Your stereo its sitting flat its only 2 screws To remove but you need to remove The carpet From The sides And you Will see it !
Dodge did not make a 1996 Dynasty. The last Dynasty was built in 1993.
You can't, it is an integral part of the computer system.
Where is coil located on a 1989 dodge dynasty at
Remove rear seat, them remove rear deck to get to the speakers.
i like to use the good old crow bar or the shot gun that always works
You have to remove the vent & bezel assembly from below the radio first, then the entire dash bezel from around the instrument cluster & radio.
Remove Wheels Remove caliper mounting bolts Slide caliper off rotor Slide rotor off hub
Well I Know you must remove the glovebox and ashtray assembly and then you can see the housing but that's as far as I got.
How do you bypass the alarm system on a 1990 Dodge Dynasty?
Why does a 93 dodge dynasty leak transmission fluid?