answersLogoWhite
Jeep Wrangler Sport
Ford F-350
DIY Projects

How do you remove the factory stereo in a 2004 wrangler?

252627

Top Answer
User Avatar
Wiki User
Answered
2007-07-23 01:30:44
2007-07-23 01:30:44

Remove the top vent cover that stretches from one end of the dash to the other above the defrost vents. It just pries off. Then remove the ashtray by pulling it out. Remove the screw behind the ashtray and the two upper screws, then pull the pry the bottom of the center bezel away from its clips and remove it. In my Wrangler there was a bar that was attached to the back of the stereo and to two bolts on the inside upper part of the dash. I used a 10mm socket with extension to remove the two bolts up above and then fought the thing out with the bar on the back. Then just undo the wiring clips.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


No, you'll need to buy an adapter which plugs into the aux input on the back of the radio.


how do you remove the doors from a 2004 jeep wrangler


Here is a step by step tutorial for a 2004 Forester.Just copy the link below.http://www.computerizedmachining.com/remove-stereo-2004-Subaru-Forester.htmlThat site will help anyone remove the factory stereo from a 2004 Subaru Forester. This site has Photos and written instructions to make sure you can get the job done right. This site also has NO ADs, No Registration required.


put the parking brake in, then put the truck in 1st gear pop the dash cover off and then remove bolts from stereo.


The correct factory tire size for a 2004 Jeep Wrangler is 225/75-15.


What sequence is used to remove radio from 2004 sububan


How to remove the factory radio and disconnect wirring harnes in a 2004 f150 ford truck


remove the aircon vent panels next to the system


you need to pop out the frame and unscrew the radio. You will need a wiring harness for an after market stereo.


Not enough - cranking it up for extended periods shouldn't damage it, but the distortion from the head unit will probably roast the factory speakers quite nicely. Don't mess with it unless it's to take it out and go aftermarket.


The real answer: Remove the stereo from the dash board and disassemble it to release the disk. I had a new stereo so I used a hammer and a big screw driver the last time I had to do this.


(H)100MMx(L)200MMx165mm(D) ON A 2004 TOYOTA COROLA


There is an amp only if equiped with factory infinity stereo with 7 speakers. If so, the amp is behind the glovebox.


remove the top dash panel closest to the windshield, then remove mounting screws for dash module.


Follow the link below. Its a step by step on how to do this.


The 2004 Jeep Wrangler has 16 valves.


pull all the knobs for your heater controls off, remove 2 Philips screws pull heater bezzel out (not off completely) then you can pull the radio bezzel off. remove screws and pull stereo out. infinity stereo the amplifier is under the drivers seat.


The 2004 Jeep Wrangler has an inline 4 engine.


The 2004 Jeep Wrangler has a 5-speed manual.


The 2004 Jeep Wrangler is a gas-powered vehicle.


There is not one from the factory, you will need to install a product that sits between the harness and the stereo, like this: http://www.pie.net/pie_store/shopexd.asp?id=10&bc=no


http://www.shareamemory.com/radio/maxima96/


We have complete instructions at our enthusiasts forum www.trailvoy.com


The curb weight of the 2004 Jeep Wrangler is 3235 lbs..


The maximum payload of the 2004 Jeep Wrangler is 800 lbs..



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.