How do you remove the front dash speakers on a 1993 Cutlass Supreme S?
Take it to Best Buy and have them switch out the speakers. That's what I did.
how do i remove the front fender to 1996 Oldsmobile cutlas supreme.
Front = 3 & half, Rear = 4x10
You must first remove the instrument panel,then remove all the screws that hold the top of the das on, then you will see you speakers. It is a lot to go threw, but i just did mine and it worked out ok. Cheers
pull out the speaker covers, get a 7mm socket, & remove the 2 screws..
Remove the wiring harness from the back of your 1995 Oldsmobile Cutlass blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.
Should be the "peel off" type Remove wheel Remove caliper mounting bolts Slide caliper off rotor Rotor should slid off hub
HogDog says 3.5 W 1.5 D/Total 2-3/8 W/Magnet 5/8" thick
I have 2 of these cieras and NO they are front wheel drive, the cutlass supreme is real wheel drive
I have a 1982 cutlass supreme and the diagram in under the hood on a front panel, If not someone may have removed it.
The Chevrolet equinox front speakers are held in place with two retaining screws. Remove the retaining screws and the wiring harness. The speakers will come out.
its located next to oil filter under the front exhaust manifold just remove fans for easier access if your as big as me....
how change front strut on1995 Oldsmobile catlass suprime
Front speakers are in the door. remove screws on the door panel, then remove the panel and you'll see the speaker
The ECM is located under the coolant reserve tank and mounted to the front of the strut tower. Only a single nut holds it in place. once you remove the nut simply pull it out.
Remove the floor sill covering, it has 5 or 6 screws, then you can access the speakers.......
The 1996 Oldsmobile Cutlass Supreme temperature sending unit can be found on the front of the engine. The temperature sending unit will be a few inches above the thermostat housing.
The oil pressure switch on a 1995 cutlass supreme is located under the hood front center of the oil pan. It is right beside the oil filter.?æ
To remove the front speakers from a Chevy Celebrity: 1. Take out the screws from the speaker grills, take the grills out. 2. The speaker is held in with screws, remove them. Lift the speakers out of the dash and unplug the wire harness.
1.- remove the doors panels 2.- remove the old factory speakers
How do you remove the factory speakers from your 92 grand am se they are the premium speakers if that matters?
Remove the dash pad, then remove the speakers from the dash frame. For the rear speakers, open the trunk and remove the brackets, that hold the speakers in place. not for the back speakers ..you have to remove the lower rear seat then remove the seat belts then the rear seat back then remove the header panels in the back seat then remove the deck cover ..the rear speakers are bolted in from the top… Read More
Remove the speaker covers, by loosening the retaining screws. Remove the speaker retaining screws. Remove the wiring harness. The speakers will come out.
If it's a 1990-97 model, yes.
should be up near the front on either the front finders or in front of the radiator near the bumper.
'would the bolt pattern for rims on an 1986 cutlass supreme be the same as on a 1992-'97 front wheel drive cutlass?
No there rear wheel drive rims are different than front drive rims
You will need to remove the front speaker covers. The speaker covers are held in place with two retaining screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install your new speakers.
You need to remove the inner part of the glove box.. you will see two screws in the compartment that the insert covered. Next take off the trim around the instrument cluster by removing the screws on the top of it that secures it to the top dash pad... remove the molding.. there will be two screws under that, one being to the right of the radio,, the other about the same to the left… Read More
Remove the doghouse (engine cover) and remove the heater duct. Then you can access both speakers through the doghouse.
Remove the speaker covers. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install the new speakers.
pull the wheel off remove the brake caliper and disc. there might be a cap in the center of the hub. if so remove it and there will be a single nut coming from the spindle remove it and the the whole assembly will come off.
What size is the hex nut to remove the caliper on the front disc brakes of a 88 Oldsmoblie Cutlass Supreme Clasic Broucham?
It should be 3/8" if it's a hex, or T-50 if it's a star (Torx).
front drivers side of motor you can follow your lines back from the condensor
under the sunroof contole panel in front of the sunroof
It is on the front right, battery sits under it.
It probably does unless it was ordered special with disc's on the front.
Remove the 4 bezel trim phillips screws around trim bezel. Unplug headlamp socket. remove headlamp.install new. replace bezel with 4 screws. yur done.
If it is the front ones, remove the wheel, get a t-50, or t-55 torx for a half in. ratchet. remove the upper and lower bolts, caliper slides off. If it is rear, remove wheel, get an 18mm wrench and take the bolts out. caliper will come out with them.
Cutlass S, yes Cutlass or Cutlass Supreme, no Interwebs search of photos will show the difference- the raised center section. Oh, for details, the 442 will NOT have the "Oldsmobile" script (or holes for it) in the left front corner.
To change the front speakers, you will have to remove the door panels to expose the speakers. Once exposed, unhook them by disconnecting all the wires.
I've got a better question, why is this question in the Chevy venture forum ?
I'm guessing that the only way to do it is to cut the metal plates in front of the speakers with a Dremel, or some kind of other cutting device.
I recommend going Crutchfield.com as they have instructions on how to install speakers in most cars.
How do you remove front door Panel on Hyundai Excel 1999 to Rplace front door SPEAKER'S
To replace the speakers in a Town and Country you will need to remove the old ones first. Consult your owners manual for how to take out your speakers.
Under vehicle, driver side, below seating area, front of fuel tank and in front of the fuel filter.
It depends what engine you have but its typically on the front of the engine(th side where the belts are) and its on the front timing cover, sometimes under the crankshaft pulley,
remove cover, unscrew, disconnect
you have to drill out the rivets then the speaker just pops out
Remove the speaker covers. Each speaker cover is held in place with two retaining screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install the new speakers.
If you have never done one before. Don't without the correct manual in front of you.
Under the hood front center of oil pan, just right of the oil filter.