VW Passat
Ford Expedition Eddie Bauer
Ford Expedition XLT

How do you remove the front door panel of a 1998 Toyota Tazz or Conquest?

Top Answer
User Avatar
Wiki User
2015-07-15 18:50:36
2015-07-15 18:50:36

as a matter of fact, i just did this yesterday to fix the lock on the drivers side. all you got to do is first lift the entire black panel that covers the lift up lock for opening/ closing the door. this panel runs all along the top ledge of the, unscrew the nut on the inside door opening latch. now the panel can just be pried open as its held together by some plastic push-in locks all around its periphery. be careful you don't rip it out too hard as the panel is cardboard, and you run a risk of tearing it up if youre not careful.

you should now be able to see the inside of the door...if not, try rolling the window up.

theres some nuts to undo inside the panel...but first you got to rip out the plastic dust protecting cover that's stuck over those big holes. . I'm not an expert.

hey, if you know anything about the conlog scimitar rca-v mk II car alarm/immobilizer installed on the 2000 model tazz by Toyota, please gimme a shout at

Related Questions

User Avatar

toyota avensis 2004 how to remove door panel from passanger side front door

User Avatar

how to remove 2012 fortuners front door pannel

User Avatar

Remove the dash or cut the front panel out - its the most annoyng job ever. Easier to change the engine...

User Avatar

remove front door panel 1995 Nissan maxima

User Avatar

remove the screw in the door handle get a pry bar flat and insert it on the side top part and pop it open ,remove the top ,remove three screws that hold the bottom portion of the panel { it;s a two part panel} then pry the rest of the panel out that it...

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.