Go to this website. It shows how to take off the door panel. http://www.kwmuth.com/techsupport/pdfs/21000110.pdf
Find a thin yet hard tool of some sort, I used a putty knife to remove both of my door panels. Wrap your tool in masking or duct tape so you don't scratch paint. Starting at the bottom, work the knife in between the panel and the metal of the door. You'll find a small plastic button clips hold the bottom in place. Carefully pry the bottom lose, if you break the clips, they sell them at Auto Zone, but IT'S A HUGE HASSLE finding the right ones. Next take out all the Phillips head screws you find. Should be three of them if i recall. two large ones in the handle/armrest and one behind the door handle itself. Also don't miss the one up near the top-front if you don't have the factory Infinity tweeters. Once those are taken out continue w/ your putty knife carefully prying the panel off until all you have left connecting the door to the panel is the wiring and door latch bars. Those are removed by taking off the small ring clips on the door panel end of the bars. And the wiring if you have it is a simple wiring harness plug. There you have it, a naked Jeep door. I highly suggest putting Dynamat or some other sound deadening material between the panel and door before you replace it, makes a world of difference in the amount of road/tire noise.
this is an easy task. there should be two or three screws holding it in. There si one in the arm rest, there should be on by the mirror and there should be one more screw. When you get the screws out, just pull on the panel straight off. Have Fun!
i removed the door panel on a friends 93 Chevy. I'm going to assume it's a similar process. there should be plastic pins every foot or so on the perimeter of the door panel holding it the metal door. you should be able to just pop the door panel off.
You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
this site shows how: http://www.wjjeeps.com/doors/doorpanel.htm
there is no drain plug you must remove the whole bottom cover.
How do you add horsepower to a cutlass 1983 supreme brougham v6 4door?
mercedez Benz 1992 300 E 4door cuope automatic transmission diagram
with your hands
Check out the following website. I think this is a for a 4 door. http://www.grandprix.net/upgrades/doorpanel.html Hope this helps. "G"
Vehicles of this era had no VIN #. They did however have a body plate that contains build information. May be on the driver's door, under the hood, inside the glove box, on the firewall, or someplace else.
In order to change the drive belt on 2000 BMW 4 door 323I, you must remove the air filter box, loosen the hose clamp, remove the harness plus, and depress the clip to remove it. Unclip the hose from the air filter box and remove it from the vehicle. Next remove the fan and fan clutch assembly. Next remove the tensioner and remove the belt.
Yes it will. I did it to my 90 integra 4door
mine gets 36+ highway. 4door 1.8 auto
What is the pAyload for a 1991chevy blazer four dood
195/60R15 is the OEM size.
you have to remove the axles by unscrewing all of the small bolts in the center hub after removing all the lug nuts. pull the axles out and then you will need to rent a axle nut socket to remove the axle nuts. then remove the entire hub with the rotors attached then flip the hub over and remove all of the torx bolts holding the rotor to the hub