Chevy G20

How do you remove the front door panels on a 1990 Chevy G-20 van with power door locks and windows?

232425

Top Answer
User Avatar
Wiki User
2008-10-23 03:38:10
2008-10-23 03:38:10

If this is a conversion van with wood trim on the panel you do the following:

1. Using a door handle spring clip tool remove the door handle spring clip and handle.

2. Start along the edge of the panel and work in one direction remove the upholstery buttons on the perimeter of the door.

3. Remove all but 1 trim screws around the door. Leave 1 trim screw attached at the top center to hold the panel during the next steps.

4. Remove the wooden trim block that houses both window and lock switches.

5. Carefully Pull away slightly and un-plug the connectors on the back of both switches.

6. Set the switch assembly to the side.

7. If equipped with arm rest on door then remove both attaching screws and set aside.

8. remove trim end caps on door grab handle if equipped.

9. Remove the screws and set grab handle aside.

10. You may now remove the last screw and pull the panel away from the door.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

http://prodactor.blogspot.com/2005/09/removing-door-panel-from-toyota.html

User Avatar

I too was looking for an answer to this question. I found an answer on this forum under 2002 Chevy Tahoe. These panels should be similar if not the same. Hope this helps.

User Avatar

You don't need to remove front door panels, the speaker grills come out.

User Avatar

this a few bolts @ the bottom they are hung on by clips take the power swites off then pull up towards the window

User Avatar

Door Panels Removal & Installation 1. Remove the sail panel (Front Doors Only). 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc.The installation is the reverse of the removal.

User Avatar

Door Panels Removal & Installation 1. Remove the sail panel. 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. 4. The installation is the reverse of the removal.

User Avatar

Chevy Tahoe remove front and rear speaker

User Avatar

how to remove the door panels to re and re the speakesrs on a 2001 navigator ? how to remove the door panels to re and re the speakesrs on a 2001 navigator ?

User Avatar

There were no 1994 Chevy Celebrities produced.

User Avatar

For removing the door side panels, See "Related Questions" below for specifics on the front & side doors.

User Avatar

Door Panels Removal & Installation 1. Remove the sail panel (Front Doors Only). (Triangle looking shape near the side view mirror) 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc.The installation is the reverse of the removal.

User Avatar

Door PanelsRemoval & Installation1. Remove the sail panel (Front Doors Only). (Triangle looking shape near the side view mirror)2. Remove the door panel by carefully lifting the panel upward to release the retaining clips.3. Remove the electrical plugs that control the windows, exc.The installation is the reverse of the removal.

User Avatar

Door Panels Removal & Installation 1. Remove the sail panel (Front Doors Only). 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. 4. Replace speakersThe installation is the reverse of the removal.

User Avatar

how i can removefront headrest for chevy suburban 2001

User Avatar

1.- remove the doors panels 2.- remove the old factory speakers

User Avatar

Tucked into the quarter panels on the front of the car

User Avatar

the back panels can be removed by gripping the end of the panel from the trunk side and pull outward s gently there are several clips that needs to be disengaged for it to come out. As for the front i have no idea..

User Avatar

Door Panels Removal & Installation 1. Remove the sail panel. 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. 4. The installation is the reverse of the removal.

User Avatar

How do you remove the front grill of a chevy avelanche?

User Avatar

Open both front doors and remove everything between the firewall and the front seat :(

User Avatar

Remove the Door Panels and remove screws holding the speakers. Door Panels Removal & Installation 1. Remove the sail panel (Front Doors Only). (Triangle looking shape near the side view mirror) 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc.The installation is the reverse of the removal.

User Avatar

You need to remove the front and rear seats. Remove the console, various interior panels and the door sill plates. Pull out the carpet.

User Avatar

there is about 7 screws in the front door and u have to take the pin out for the window crank unless its power windows there s screw where the handle is and where u open the door on the inside


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.