answersLogoWhite

0


Best Answer

Three Auto Upholster store tried to remove the visors from my 1998 Oldsmobile without success. My visor are literally disintegrating. I can't find replacement any place. I printed the pictures to them and followed them to no avail. (?)

Please any recommendation will be highly appreciated.

alvgcontact@gmail.com

User Avatar

Wiki User

โˆ™ 2013-06-20 20:22:03
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you remove the front driver side quarter panel on a 1998 Oldsmobile Intrigue?
Write your answer...
Submit
Related questions

How do you remove driver's side fuse panel cover on 1998 Oldsmobile Intrigue?

The fuse panel cover is on the passenger side in a 1998 Oldsmobile intrigue. Same location as vehicles that have it on driver side. Just pull on it and it will pop off.


How do you drain the radiator in a 1998 Oldsmobile intrigue?

Remove the lower radiator hose.


How do you remove a windshield wiper motor on a 1999 Oldsmobile intrigue?

Take it out with your muscle.


The cup holder in my 1998 Oldsmobile Intrigue has come off of its tracks and has fallen into the armrest and is stuck there. How can I fix the armrest cupholder in my Oldsmobile Intrigue?

Remove (or have a professional remove) the center console. The cup holder may or may not be repairable.


Remove AC compressor on Oldsmobile Intrigue?

.You can remove the air conditioner compressor, from your Oldsmobile automobile, by removing the compressor belt. Remove the air conditioning Freon. Remove the Freon lines. Remove the retaining bolts


Where is the radiator drain cock for a 1999 Oldsmobile Intrigue?

On the 1998 Intrigue it is on the rear side of the radiator, in the lower left hand (driver) side. May need to remove the lower shroud (5 bolts) to gain access more easily.


How do you change the crank shaft position sensor on an Oldsmobile Intrigue?

For 3.5l, remove starter.


How do I remove the AC clutch pully on a 99 Oldsmobile intrigue 3.5L?

You need a Z7 Clutch puller.


How do you remove a governor from a 1998 Oldsmobile intrigue GL?

You can't take off the "governor" on any computerized car.


Where do you find the flasher for a 2000 Oldsmobile Intrigue?

It is right behind the hazard flasher switch on the dashboard, remove the air outlet to the right of it, just pops out with a straight screw driver. The switch /flasher is a solid state device.


How do you change a heater core in an 98 intrigue?

You will need to remove the water supply hoses from your 1998 Oldsmobile Intrigue heater core. Remove the heater core retaining bolts. Reverse the process to install your new heater core.


How do you install fuel pump on 1999 Oldsmobile intrigue?

You must remove the fuel tank in order to access the fuel pump.


How do you remove the water pump on a 1998 Oldsmobile Intrigue?

Remove the serpentine belt and the altenator. The water pump is behind the alternator. Make sure to drain the antifreeze.


How do you remove the battery on a 1998 Oldsmobile Intrigue?

you have to remove the bracket that goes over the top of the battery then its just a matter of unbolting the hold down bracket and the cables


Show you a diagram of where the crankshaft sensor is located on a 2000 Oldsmobile Intrigue?

Is this a 3.5L Intrigue V6 engine? If so, it should be behind the left exhaust manifold. You will need to remove the starter to gain access.


Where is oil filter on a 2000 Oldsmobile intrigue?

It is inside the oil pan.. Lay down look at the oil pan you will see a cap that you have to remove..


Where is the water pump located on a 1998 Oldsmobile intrigue?

passenger side of the motor must remove the serpentine belt there is a diagram on the left side of the motor compartment


Crankshaft position sensor 2002 Oldsmobile Intrigue 3.5L?

depending on the year, I have a 2002 intrigue, it is located just above the starter, it needs to be removed to remove the crankshaft sensor, 15mm for starter and 10mm for sensor 1 bolt , not to difficult.


How do you replace the wheel bearing on a 2000 Oldsmobile Intrigue?

remove the hub then remove the locking ringon inside of hub press hub and baring out then press hub out of inner baring surface reverse procedure to install.


How do you replace a crankshaft position sensor on a 1999 Oldsmobile Intrigue 3.5L?

It is located above the starter. you must remove the starter for access. Make sure you disconnect the battery first.


How to replace the AC control head in my Oldsmobile Intrigue?

Pull the plastic trim that surrounds the radio and center stack, remove the screws that hold it in, pull it out and unplug it. Reverse to install.


How do you replace the throttle position sensor in a 98 Olds intrigue?

The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.


How do you replace rear turn signals on an Oldsmobile Intrigue?

You have to remove the tail light assembly, there's 3 butterfly nuts, I believe one of them holds the carpet up, remove that one and pull the carpet down, remove the other 2 nuts and pull


Can a diagram of where ignition module is located on a 1998 Oldsmobile intrigue?

under the ignition coils. it is flat comes off after you remove the three numbered igniton coils. they plug into the module underneath them.


Where is the location of the turn signal flasher in a 1999 Oldsmobile intrigue?

It is integrated with the hazard flasher switch on the dash. I've heard the easiest access is to remove the A/C vents, but never tried it.