Saturn S-Series
Chevy Blazer S-10
Ford Ranger XL
Ford Ranger XLT

How do you remove the front left fender on a 1995 Saturn SC2?

242526

Top Answer
User Avatar
Wiki User
Answered
2006-09-10 02:22:04
2006-09-10 02:22:04

open the hood and look for bolts along the side your taking off, then look under and on the sides and find all bolts and just unscrew

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Remove the driver side front wheel, remove the inner fender liner, remove the tie down bracket, remove the battery cables and then the battery

Remove the positive cable from your 1995 Saturn battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.

Jack up your car. Remove the wheel/tire assembly and then just unbolt/unscrew the fender liner from the fender. Pull it out! Simple as chewing lettuce!

should be 3 10mill bolts on it. unscrew collar on fender and pull down out of fender

It actually isn't that hard. Remove the front right wheel and fender liner. Use a 9/16" wrench to loosen the serpentine belt by turning the wrench clockwise. Slip the belt off the alternator. Then remove the wires and the bolts that hold the alternator to the engine. Installation is the reverse of removal.

remove the four bolts at the front and the rear

ON THE 1995 BUICK RIVIERA THE HORN IS LOCATED UNDER THE LEFT HAND SIDE FENDER. U WILL HAVE TO TAKE OFF THE TIRE AND REMOVE THE FENDER PANEL. THE HORN WILL BE ON THE RIGHT SIDE OF THE LEFT INNER FENDER.

The battery is under the washer fluid container. You must remove this and then the small cross member to get to the nut which holds the battery. It is easier to remove the left front fender liner and access the battery there.

remove front door panel 1995 Nissan maxima

It is clockwise as you are facing the front of the engine from the right fender.

I think you have to remove the driver's side front tire and the battery is up in front of that. Believe it or not!

left front fender area behine the head light

The blower motor is mounted on the firewall at the passenger fender you must remove the radiator overflow tank and the ecu to remove it.

easiest way is jack up the truck place a jackstand under the frame remove left front tire and inner splash shield if needed and remove the spark plug through fender well

To get to the pump you must remove the left front wheel. The pump and holding tank are located behind the front of the plastic fender liner. Be careful removing the plastic pins that hold the liner to the fender, you will want to reuse them. There is one or two bolts at the very front of the liner. I would remove those first, then see how many of the plastic pins must come off. The pump is plugged into the tank. As you know, all you can see under the hood is the filler tube. It's all hidden behind the fender liner. Hope this helps!

Loosen the screws of the lower grill and headlamp assembly so that it can be removed from the fenders. Remove the upper grill fasteners and remove the grill. Take off the headlight housing. Remove the headlamp motor and housing. Take out the headlight. Now the fender can be unbolted and removed.

It is located in front of the engine. The top yellow.

Left front inner fender next to the air cleaner box


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.