Lift the front end and secure it on jackstands. Remove the front tires and place under the vehicles frame. Use a wrench or socket to remove the six bolts on the automatic hub locker. Use a small hose puller to remove c clip and the ring behind it inside the hub. Use a wrench or socket to remove brake caliper andcaliper mount. Remove remaining hub piecesand use a medium phillips head screwdriver to remove two to three small screws and then use your small hose puller to remove the bearing rataining ring. Use again your small hose puller to unscrew the remaining bearing retainer and theentire hub should slide out.
Remove wheels Remove caliper ( 2 mounting bolts) Slide caliper off rotor Rotor should slide off hub
pull off the front wheels. remove the calipers. remove the two screws that hold on the rotors. replace the rotors and reverse the procedure.
Most Honda brake rotors require a large slide hammer as they are not only pressed onto the hub, but also rusted which makes it very hard to remove. This may well require an experienced technician.
how do you remove front rotors from a chev 2004 silveraldo crewcab not 4wd
The pump is set into the front of the engine block. You have to remove the timing belt to get to it.
First remove the right and left tires, and then proceed to remove the rotors. After you have replaced the rotors put them back on.
Remove the tire and wheel. Remove the brake pads and break hardware. The brake rotor will slide off. You may need to tap the rotor with a hammer.
With the wheel off, remove the calipers, then the rotors just come off.
how to remove front rotors on 2003 Nissan fronter 4 wheel drive pick up
remove stud locks
14mm wrench. remove 4 nuts from the front flange and 4 nuts rear flange. Careful with the driveshaft it's aluminum.
Remove the wheel, the calipers and the rotors, reverse procedure with new rotors.