how to remove starter on 1996 chevrolet 2500 with 6.5 diesel engine
two lug's dumb a--!
you will have to drop the tank and remove the pump unit.
It comes in handy to know the weight of a vehicle. The 1979 2500 Chevy pickup has a curb weight of 6,236 pounds.
A Dodge 2500 has 8 per wheel.
It is screewed into the front Differential, towards passenger side but in the middle of the housing.
Yep... It should have one.
It sure will.
Very simple! Take off the wheel, just slide the old one off, then slide the new onw on!
Remove the water hose from the top of your 1996 Chevrolet 2500 thermostat housing. Remove the thermostat housing retaining bolts. Lift the old thermostat out and drop in the new thermostat.
It is inside of the fuel tank. You will have to remove the tank are raise the bed up to get it out of the top of the tank.
Remove Distributor,remove drive gear,remove shaft,remove pickup coil.
Not without fabrication.
There is none.
Depending on the type of plug, the gap for a 1990 Chevy 2500 pickup is between .045 and .060. The plugs should come pre gapped.
the gross vehicle weight rating of a 1989 Chevrolet 2500 pickup is 8,600 lbs.
1500 is a 1/2 ton 2500 is a 3/4 ton 3500 is a 1 ton
Front, back, and both sides.
Never seen one.
The most common engine used was the 5.7L 350 V-8. But it may have the 6 cylinder in it. Count the spark plugs.
The 1988 Chevy K 2500 pickup truck has a listed gross vehicle weight of 4360 pounds. The gross vehicle weight does not include any fluids.
See your local GM dealer for a reman swap.
how do you remove the pince bolt cover of a 2005 Chevy express van