There is no such thing.
It should. Both years are 3rd generation so it should fit in.
It is conveniently located on the passenger side forward surface of the defrost air distributor. To access it, remove the dashboard cover, remove the air conditioner controls and radio, remove all right side lower dashboard fasteners, noise deadening panels, etc, pull dashboard assembly away from firewall, rotate defrost air distributor slightly clockwise, and you can reach in and remove the module (grey) with a 7mm open end wrench this guy is exactly right.
It is located on the firewall in the passenger's footwell. You have to remove the trim panel under the dashboard to see it.
The dashboard on a 1991 Honda Civic is held on by several screws. Loosen and remove all of the screws. Then proceed to pull the dash out.
Most are located in the fuel tank--some have access port under trunk or rear seat, you may have to remove fuel tank to access
Remove fuel tank
The 1991 Mercedes Benz dashboard is held in place with eight retaining bolts and 12 retaining clips. Remove the retaining bolts and pry outward on each retaining clip.
Yes, but 1991 rims will NOT fit a 1993 camaro
behind the dashboard on the passengers side
General Motors products do not use inertia/reset switches.
push in hard on the bottom of the cushion then pull up
Remove inner door panel for access
top of the steering column near the bottom.
no it will not
Disconnect batt. Drain Raidiator coolant.Remove Dashboard. Unhook both heater hoses located on firewall in engine compartment. remove airbox nuts in engine compartment. remove retaining screw for core in cabin. remove core.
The alternator has a built in voltage regulator.
i believe theres only one and its located in the exhaust pipe
There were no IROC Camaros in 1991
You will have to remove the transmission and torque converter from the car to get to the front seal.
Remove the instrument panel pad. Remove the speaker attaching screws. Remove the speaker and disconnect the electrical connector. Installation is the reverse of removal.
It screws into the intake manifold next to thee thermostat housing.
If it's auto it is located in the centre column beside the shifter.
reset the brakelamp light on the dashboard - Honda prelude 1991