answersLogoWhite
Headlights Tail and Brake Lights
Oldsmobile Aurora
Ford F-250

How do you remove the headlight module on a 1997 Olds Aurora to allow for bulb replacement?

212223

Top Answer
User Avatar
Wiki User
2015-07-15 19:54:56
2015-07-15 19:54:56

I read this also in my owners manual for my '97. But I was able to squeeze my hand in and change the bulb without removing the headlight. I changed both bulbs this way and I do not have small hands. Good luck!

1

Related Questions

User Avatar

Open the hood to the engine compartment. Remove the headlight wiring harness. Remove the headlight assembly bolts. There are four headlight assembly bolts. The headlight assembly will come out.

User Avatar

Headlight Bulb Replacement * If your going to replace the left hand light bulb remove the air filter housing * Disconnect the electrical connector unless replacing the headlight housing * Rotate the bulb holder counterclockwise and pull it out the bulb and holder assembly Headlight Housing Replacement * Remove the front bumper cover * Remove the upper headlight housing mounting bolt and pushpin * Remove the lower headlight housing mounting bolts * Pull out the headlight housing assembly and disconnect the electrical connector

User Avatar

remove the cover across the the front of the radiator should be 3 screws once you have done that you will see 3 metal pins sticking down in the headlight remove and headlight should come right out

User Avatar

The radiator cooling fan relay is located under the drivers side headlight, Mine was riveted. remove air intake,remove headlight module,remove plastic air intake 1 Phillips screwdriver, remove module and replace if riveted drill out an replace w.screws

User Avatar

BRING SOME TOOLS TO THE JUNK YARD--GO PRACTICE.......

User Avatar

Headlight Bulb Replacement * Open the hood and locate the bulb assembly on the back of the headlight housing.On the right side headlight remove the two screws and the plastic shield for access to the bulb * Unplug the electrical connector and detach the retaining ring * Withdraw the bulb assembly from the headlight housing * Without touching the glass with your bare fingers insert the new bulb into the assembly Headlight Housing Replacement * Disconnect the negative battery cable * Remove the headlight bulb * Remove the radiator grille * Remove the parking light housing * Remove the retaining nuts and bolts detach the housing and withdraw it from the car

User Avatar

Headlight Bulb Replacement * Open the hood and locate the bulb assembly on the back of the headlight housing.On the right side headlight remove the two screws and the plastic shield for access to the bulb * Unplug the electrical connector and detach the retaining ring * Withdraw the bulb assembly from the headlight housing * Without touching the glass with your bare fingers insert the new bulb into the assembly Headlight Housing Replacement* Disconnect the negative battery cable * Remove the headlight bulb * Remove the radiator grille * Remove the parking light housing * Remove the retaining nuts and bolts detach the housing and withdraw it from the car

User Avatar

If it's the same as my 1999 2 door 4x4. You have to remove the grill. Then the headlight modules are right there and easy to get too.

User Avatar

Open the hood and you will find 2 bolts to remove the entire headlight assembly. You can then replace the bulb.

User Avatar

Headlight Bulb Replacement * Open the hood and locate the bulb assembly on the back of the headlight housing.On the right side headlight remove the two screws and the plastic shield for access to the bulb * Unplug the electrical connector and detach the retaining ring * Withdraw the bulb assembly from the headlight housing * Without touching the glass with your bare fingers insert the new bulb into the assembly Headlight Housing Replacement* Disconnect the negative battery cable * Remove the headlight bulb * Remove the radiator grille * Remove the parking light housing * Remove the retaining nuts and bolts detach the housing and withdraw it from the car

User Avatar

You can remove the headlight by removing the retaining screws. Remove the headlight wiring. The headlight should easily come out.

User Avatar

Remove the two headlight mounting bolts and slide the entire headlight assembly forward. You can then disconnect the Bulb from the sockect and remove the bulb from the headlight housing. Installing is just as easy. Install the new bulb, connect the blulbs electrical connection and re-install the headlight. Should take about 5 minutes all togather.

User Avatar

2007 Cadillac DTS headlight bulb replacement: Purchase the correct replacement headlight bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the headlight bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).

User Avatar

1999 GMC Yukon headlight bulb replacement: Purchase the correct replacement headlight bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the headlight bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).

User Avatar

Ok I have just purchased a set of replacement headlight assemblies for my 2001 tundra How do I get to the bolt on the bottom left or right to remove the assembly.

User Avatar

Open the bonnet. Remove the grill. Remove the screws holding the headlight in. Carefully pull the headlight out. Remove the cap on the rear of the headlight.

User Avatar

How to remove headlight assembly on 2003 Lexus GX470

User Avatar

Headlight ReplacementLeft sideMake sure you have anti-theft codes for the audio system and navigation system (if equipped). Make sure the ignition switch is OFF.Disconnect the negative cable from the battery first, then disconnect the positive cable.Remove the battery.Remove the front bumper.Remove the four mounting bolts, and pull the headlight (A) out slightly.Disconnect the connectors (B) from the headlight.Remove the two bolts and the corner upper beam (C) from the headlight.Install the headlight in the reverse order of removal.Connect the battery cables to the battery.Do the steering column position memorization.Enter the anti-theft codes for audio system and navigation system (if equipped), and set the clock.After replacement, adjust the headlights to local requirements.Right sideRemove the front bumper.Pull up the front portion of the fender trim, and remove the mounting bolt from the inside of the fender.Remove the three remaining mounting bolts, and pull the headlight (A) out slightly.Disconnect the connectors (B) from the headlight.Remove the two bolts and the corner upper beam (C) from the headlight.Install the headlight in the reverse order of removal.After replacement, adjust the headlights to local requirements.

User Avatar

Can't get specific without MODEL of 2002 Jaguar. Here is the general replacement procedure for headlight bulb replacement: Purchase the correct replacement headlight bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the headlight bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).

User Avatar

1992 Cadillac Fleetwood headlight bulb lamp replacement: Purchase the correct replacement headlight bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the headlight bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).

User Avatar

2000 Mitsubishi Eclipse headlight bulb replacement: Purchase the correct replacement headlight bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the headlight bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).

User Avatar

2006 Honda Ridgeline headlight bulb lamp replacement: Purchase the correct replacement headlight bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the headlight bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).

User Avatar

# Disconnect negative battery cable # Remove the retaining screws and detach the headlight bezel # Remove the headlight retainer screws taking care not to disturb the adjusting screws # Remove the retainer and pull the headlight out enough to allow the connector to be unplugged # Remove headlight now # Disconnect negative battery cable # Remove the retaining screws and detach the headlight bezel # Remove the headlight retainer screws taking care not to disturb the adjusting screws # Remove the retainer and pull the headlight out enough to allow the connector to be unplugged # Remove headlight now

User Avatar

Remove instrument cluster in a 2003 olds aurora

User Avatar

Remove the wiring harness from the back of the headlight. Remove the headlight assembly bolts. The headlight assembly will come out.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.