I shall assume that you are talking about the wiper arms them selves as opposed to the motor drive assembly.
Its very straightforward, pull back the black plastic vover at the end of the wiper shaft and this will expose a 10mm nut. Undo this and the arm will just pull off. may need some freeing oil or persuasion. Hope this helps
you have to remove the wipers and cowel panel from ffire wall to reach it
The are out of time. Remove the cowling so that you can see the arms that control the wipers. Somewhere in that system, a nut is loose and has allowed the whole assembly to shift or get out of adjustment.
Windshield wipers not turning off is not a common problem in the 1997 Jeep Wrangler. Remove the windshield wiper fuse to turn them off.
The front wiper arms on a 1997 Mercury Villager clip off once they are bent backwards. To install the new wipers simply slide them into the clip.
Go to the fuse box at the driver's side and remove the radio fuse for 3 hours then replace.
Unscerw the dash board, replace burnt bulbs, screww back dash board
Up until 1997, Volvo was still 100% Swedish owned and built.
There is no 1997 Impala.
the wiper motor is located under the cowel the black vent under the hood on the drivers side of the car pull the black tabs up and undo the wipers to remove the cowl
The fuse box is located behind the glove compartment on the passenger side. To get to the fuse box, you have to remove the glove compartment by holding it up slightly and sliding the woven strap (which is holding it in place) out to the right. The fuses for the wipers are #14 for the front and #6 for the rear.
You must remove the wipers, cowling, wiper motor and linkage assembly. Then you will remove the power steering lines, connectors and tie rod ends. Next, remove the bolts holding the rack to the body of the car, then remove it through the hole where the wiper motor and linkage assembly was located.
Remove the vent panel located at the base of the windshield. Locate the motor. Replace. Be sure and realign the wipers to specification ... or else, one or both would be offline.
It is an OBD2 car if that is what you are asking.
Will depend on model of 1997 Oldsmobile. See Sources and Related Links below to lookup.
It goes in relay slot #8 for the wipers.
my 1997 ford f-150 windsheld wipers and electric windows and dome lights are not working, they come on sometimes and sometimes they do not .
Under the coin holder in the center console. Just pull up on the coin holder and remove and you will see OBD II port.
Use only the weight recommended by Volvo and I doubt that they recommend 10w40.
The 1997 Volvo 850 low pressure port is located on the air conditioning compressor. The low pressure port will be on the right hand side of the compressor.
When my Volvo broke an alternator drive belt the majority of the warning lights came on.
The 1997 Volvo 850 evaporator drain tube is located on the bottom of the air conditioner compressor. The evaporator drain tube carries condensation away from the engine.
The fuse that controls the windshield wipers on a1997 Honda Civic is found inside the cabin of the car. It is in the fusebox, in slot number 26.