answersLogoWhite

0


Top Answer
User Avatar
Wiki User
Answered 2014-10-07 01:58:03

Begin by removing the water supply hoses from your 1989 Chevy heater core. Remove the heater core retaining bolts. The heater core can be removed.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

Do I need to pull dashboard to get to heater core in a 1989 Chevy Celebrity?

No................... Its located in the center of the vehicle but you will need to remove the side panels if equipped and then remove the lower heater core cover and the heater hoses.............


Where is the heater core on a 1989 Chevy G30 van?

The 1989 Chevrolet heater core can be found behind the kick plate. You will need to remove the passenger side kick plate in order to access the heater core.


What is the best way to get to the heater core in a 1989 Chevy celebrity?

Disconnect the negative battery cable and drain the cooling system.Disconnect the heater hoses from the heater core inlet and outlet connections in the engine compartment.Allowing residual coolant from the heater core to drain. Cap the openings.Working inside the vehicle, remove the lower instrument panel sound insulator.Remove the heater floor outlet duct screws or clips and remove the duct.Remove the heater core cover by removing the attaching screws and clips.Remove the heater core cover.Remove the heater core retainers and remove the heater core.


How do you replace the heater core on a 1989 Chevy Corvette?

== ==


What do you need to remove before replacing the starter on a 1989 Chevy caprice with a 305 engine?

The battery cable for sure.


How do you replace heater core 1989 Chevy s-10 4.3?

The heater core is removable from under the right side of the instrument panel.Disconnect the negative battery cable.Position a drain pan under the radiator, open the drain cock and drain the cooling system to a level below the heater core.Disconnect the heater-to-engine coolant hoses from the core tubes on the fire wall, in the engine compartment.From the passenger compartment (under the dash) remove the heater core rear case cover-to-cowl screws, then remove the cover from the vehicle.Remove the straps or brackets from each end of the heater core.Carefully remove the heater core from the cowl and case.


Must you remove the camshaft to replace the timing belt of a 1989 Chevy Celebrity 4-cylinder?

no The Chevy Celebrity 4 cylinder engine doesn't use a timing belt, it uses a timing gear. To replace the gear it is necessary to remove the camshaft from the engine as it is a press job. To remove the camshaft it is necessary to remove the engine from the car.


Does a 350 Chevy engine fit into a 1989 Chevy Cheyenne?

Yep


How do you change a 1989 Chevrolet Cavalier heater core?

The water from your 1989 Chevrolet Cavalier cooling system. Remove the heater core water supply hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.


How do you remove and replace a g 30 series heater core on a 1989 Chevy motor home with air conditioning?

under the right side dash. you remove heater lower cover heater core right behind cover there are some hiden screws close to the fire wall good luck


How do you remove the ignition switch on a 1989 Chevy Corvette?

Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.


How do you remove the oil pan on a 1989 Chevy k2500 5.7 350?

You will need to drain the oil from your 1989 Chevrolet 5.7 liter engine oil pan. Remove the oil pan bolts. The oil pan will come off.


How do you remove a heater core in an 1989 Nissan Micra?

First remove the dashboard to access the heater box and core! Then reversal of strip down to rebuild.


Why doesn't your 1989 ford ranger xlt heater get hot even though you just put in a new thermostat and it is full of antifreeze?

Check both the supply and return heater hoses from engine to heater for blockage or clogging: remove them and flush. Also check the inlet and outlet pipes on the engine and heater core for gunk buildup and leakage.


You need to know how to remove the crank shaft positioning sensor for a 1989 2.8 lt. Chevy Celebrity with a V6 Thanks?

The answer depends on what engine you have.


Where is the fuel pressure regulator located on a 1989 Chevy silverado K1500 with 5.7 liter engine?

Where is the fuel pressure regulator located on a 1989 chevy silvarado with 5.7 liter engine


Location of the heater core on a 1989 Chevy Corsica 2.0?

inside dashboard on passenger side


Where is the blower motor relay on a 1989 Chevy Caprice?

it is next to the firewall near the heater coil


Is the heater control valve really necessary on a 1989 Jeep Cherokee?

No, it is not required. You can remove it and splice the heater hoses together.


Will a 2.8 engine from a 1988 Chevy beretta fit a 1989 Chevy blazer?

Yes it will, but you have to put all the blazer engine stuff onto the beretta engine...


How do you remove the transmission on a 1989 Chevy Caprice Classic Brougham?

with tools


If there is coolant all over your passenger floor board and you need to change the heater core how do you do it on a 1989 Chevy S-10?

Answerremove the lower dash on the passenger side. This is not a fun job.


What kind of engine are in a 1989 Chevy Blazer?

It will be a 305 or a 350 fuel enjection engine ( TBI )


Where are heater hoses on a 1989 Chevy Celebrity?

On a 1989 Chevy Celebrity the heater hose leaves the water pump via a hose barb then runs along the top of the passenger side frame rail and then into the heater core. The heater core is in the firewall below the blower fan on the passenger side of the car. The return hose leaves the heater core and runs along the firewall then to the water outlet below the thermostat.


What motor is in a 1989 Chevy Silverado 1500 have?

Its a 5.7L 350 engine