Hi. i have an 89 lx with a digital dash. well that is not too hard at all! first take off the stering wheel, 2 screws on the back and so on. it will take a bit of a good pull to get the wheel off. its really hard! then there is 3 screws above the speedometer, remove them. then there is about 4 screws below the ignition accross the bottom.then the whole dash around your instroment panel comes out. (may have to adjust the steering tilt to get it off) and then you can see the whole ignition. that is all that i know about getting her out. well any other Q's email: evanwolfe@mail.com
where are timing marks on 89 ford probe 4 cylinder I have the bottom not the top
does anything need to be taken off to remove a started on 89 ford probe
Ford Probe was created in 1989.
To set the ignition timing on a Ford Probe GT 95 with an MX engine, remove the two 12 mm head bolts holding the distributor in place. Then rotate the distributor to set the ignition timing.
how to check the fluid on a manual transmission for a 1989 ford probe gt
The 1991 Ford Probe spark ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
Defective ignition switch or tumbler assembly.
The first model year of the Ford Probe ( in North America ) was ( 1989 )
if you have the exhaust manifold, oil lines, etc. from the 89 GT then yes.
If you have the original factory tank, it has a drain plug (bottom center) you can remove with a wrench.
Built into the distributor.
How do you remove ignition tumbler 1998 ford Mustang?