how to remove key stuck in ignition switch in Chevy colbalt
Try super glue on a pencil.
There is an access cover just under the ignition cylinder. Remove this to remove the stuck key.
remove battery cable
You probably need to get an automotive locksmith to pull out the barrel of the ignition, clean it out and open up the "vee" that allows the levers to turn.
stuck to the washer jug in the finder
There should be a lock on the ignition a push button that you push and turn to remove the key
To remove a key that is stuck in the ignition on a Peugeot 406 HDI, make sure that the car is in park. Then try to remove the key. If this does not work, spray the ignition mechanism with WD-40 after pulling out the key as far as possible. Then work the key in and out until it comes out.
Well, it sounds like the chip that is in your key may have broke or got stuck on a part of the ignition. I had that problem. This happened not long after I had had to have the ignition replaced?!?
See You-Tube Video : http://youtu.be/lBNUuO4ldfI How to Remove a broken key from an Ignition. Using the Broken Key Extractor Kit from: www.WedgeCo.com
Key is stuck in ingnition
Use the opportunity to replace the ignition. Key needs to be in On position for removal.
You can't, you have to replace the ignition switch
Try to put your car on the parking breakes.
If the key is stuck in the ignition you will need to get it looked at by the dealer. One temporary solution is to pop off the cap next to the shifter console and you should be able to remove the key by sticking a pen in there.
is it a ford? push the key in further and then turn it
light a fire cracker and put it near the point of stuckness, you may need to buy a new ignition system but atleast the key will be out
Stuck open thermostat. Plugged up heater core. Temp blend door malfunction.
Cut them off- after 10 years it's time to replace
Low coolant, failed waterpump, stuck thermostat, missing belt, inoperative fan, plugged radiator.
In my case it was the ignition switch itself had overheated and seized up. Replace the switch (have to lower the column, disconnect the wiring plug from the switch, and remove/replace the switch.) Clean all connections to the switch, make sure they're connected solidly and not heating up again.
If your 300zx has no power to the entire car and the key is stuck in the ignition you have to press the emergency button located in the ignition. Simply remove the black piece from your ignition.(its a black cap)..and when removed you will see a small red button..if you see that push that and press the "push" black button, turn your key and pop it out.
if there's no juice to the system then its stuck. plug in the battery and it will release. if theres battery then im not sure.
you get a pair of pliers and jiggle it out and turn the wheel left and right and it should come out
make sure it is COMPLETY in park. Sometimes it will not release the key unless it is totally "locked" down.