pull trim around radio, speedometer. pull gauges radio and ac controls there is two screws .pull them. then pull electric wires to get releases cable out the key has to be in on position
== ==
i have a 2003 Pontiac grand am, no start, does not even turn over. could it be the ignition switch?
You will need to remove the retaining ring at the top of your 1995 Dodge Grand Caravan ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
it is located on the steering column
The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.
the ign switch or the key & tumbler ???
how much to insall a ignition to a pontiac grand am se 1999?
It's really easy the switch is in the steering colume.
The 1994 Pontiac Grand Am ignition lock cylinder is held in place by the retaining ring at the top of the cylinder. Remove the retaining ring. Remove the wiring harness from the back of the cylinder.
first remove the dash trim around the switch. the trim should just pull off. its held in by push clips. next remove the screw that holds the switch, push in on switch a little then wiggle it out. remove the electrical connection from back of switch, then pull switch out. to install is reverse of removal.
I don't know how to change the ignition switch but I have some advice. Don't screw with the ignition switch, buy the whole steering column. It will be cheaper and easier to change.
The switch is on the steering column about 18 inches from the floor under the dash. There are 2 screws that hold it on.