Remove steering wheel, turn signal (4 screws), and torx holding ignition, reverse to reinstall.
how to remove lock cyliner switch 1988 Isuzu pickup
If your 1988 Chevy Corsica key only turns in the ignition and does not start the automobile, it is probably unfixable. Remove the ignition switch retaining ring. Slide the out and remove the wiring harness. Reverse the process to install the new ignition switch.
Ignition switch and lock cylinder removal 1988 Dodge Ram 50.Disconnect the negative battery cable from the battery.Remove the steering column cover to gain access to the ignition switch/lock cylinder.Using wire cutters, remove the cable band.Remove the bolts that hold the ignition switch/lock cylinder to the steering column.Unbolt and remove the key reminder switch and remove the switch lock cylinder from the steering column.
module locatedwhere is the module on a 9 Chevy blazer
How do i change the ignition switch in a 1988 Chevy camaro
I have to jump start my Pontiac Bonneville 1988 everyday I drive it why is that.
You need to remove the steering wheel first with a puller. There is a latch you can trip with a small screwdriver that will let the ignition switch slide out. Simply replace the switch and put the steering wheel back on.
Remove the steering wheel. (you will need a steering wheel puller) Remove the turn signal switch. It is not necessary to completely remove the switch from the column. Pull the switch rearward far enough to slip it over the end of the shaft, but do not pull the harness out of the column. Turn the lock to Run. If necessary, remove the ignition key. If equipped, remove the buzzer switch assembly. Remove the lock retaining screw and remove the lock cylinder.
how do you remove the ignition control module on a 1988 ford f-250 pickup?
The 1988 Jeep Cherokee fuel pump relay switch is located on the firewall in the engine compartment. The switch will be on the drivers side of the firewall.
A 1988 Jeep Cherokee does not have an inertia switch. The fuel system is computer controlled with relays.
how do install key ignition switch 1988 Chevy s10