If you talking about were the key goes into the Ignition then try this. I have a 1991 aerostar. Disconnect your battery. Then remove the screws holding the plastic steering wheel cover. then by looking at the bottom of the steering wheel near the ignition you should see a little button (or what looks like a hole) With the key in the ignition push this button/hole and pull on the ignition (not Majorly hard) Slowly turn the key and it should come out easaly when it is in the on position.
Add your answer:
Related Questions
How do you remove the ignition switch on a 1989 Chevy Corvette?
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
How do you change the ignition switch on a 1989 Chevy Blazer S10?
You will need to remove the retaining ring from the top of your 1989 Chevrolet blazer ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
How can i replace an ignition switch in a 1989 Oldsmobile cutlas ciera sl?
Remove the retaining ring from the top of the ignition switch. Pull the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
How do you replace a 1989 Mercedes Benz 300sel ignition?
Retaining ring from the top of your 1989 Mercedes-Benz ignition switch. Slide the ignition switch out. Remove the wiring harness. Reverse the process to install your new ignition switch.
How do you remove the ignition switch in a 1989 Ford Aerostar?
ok here goes/to remove/rotate lock cylinder to lock position.if equipped with tilt steering remove upper extension shroud.remove ignition switch connector then drill out break off bolts connecting the switch with a 1/8 in drill bit remove the two screws from actuator pin. to install rotate key to run positioninstall switch by aligning holes on switch casting with holes in lock cylinder install break off bolts and tighten until heads shear off. have alot of patience.
How do you remove-replace a 1989 Vanagon ignition switch?
Here is a link to an illustrated step-by-step procedure for replacting a Vanagon ignition switch: http://carboncow.net/vanagon/projects/ignition_switch.htm
How do you install ignition switch on 1989 Chevy G 10 van?
how do you install new ignition switch on 1989 chevy G10 van?
Where is the fuel pump reset switch on a 1993 Ford Aerostar XL?
On the 1989 Aerostar it is under the dash near the passenger door.
How do you replace an ignition switch on an 1989 camaro?
switch itself or key cylinder?
How can you start a 1989 mercury cougar with a broken ignition switch?
how can you start a '89 mercury cougar with a broken ignition switch?
How do you remove an ignition lock on 1989 GMC Sierra?
== ==
Where is the relay switch located on a 1989 Ford Aerostar?
On the passenger side fire wall in engine compartment !
How do you replace the ignition switch on a 1989 Jeep Waggoner?
you have to remove the steering wheel and the turn signal. this requires special tools that can be purchased or rented cheaply.
Why won't my wipers stop on 1989 Aerostar after replacing the switch and motor and the wipers still run when there is no switch installed and have no intermittent mode could it be the governor?
it is possible
How do you locate the ignition switch on a ford Bronco II 1989?
If you know where to put the key in, you know where the ignition switch is... Actually, safe to say you should stay away from it.
Is there a reset switch for the ignition on a 1989 Dodge colt gt turbo 1.6 liter?
No.
Where is the oil pressure switch on a 1989 ford aerostar?
On a 1989 Ford Aerostar : I believe the oil pressure sending unit for the oil pressure gauge on the 4.0 liter EFI , V6 engine is on the drivers side of the engine below the power steering pump
How do you remove and replace the ignition coil on a 1989 Toyota Celica?
you suck it up
Why won't a 1989 Cadillac DeVille start if the battery alternator starter are all good and the wiring has been checked?
Fuse Link @ starter--- Ignition Switch------- Netural Saftey Switch- Bad ignition switch, or bad neutral safety switch.
Where is the flasher for a 1989 Chevy Cavalier?
It is located by the ignition switch on the right side of the steering column.
Can't start 1989 Chevy Suburban with the key only by directly wiring starter is there a fuse link from the ignition wiring to the starter?
Generally the problem is either a defective neutral safety switch or a bad ignition switch (not ignition key lock).
How do you adjust the ignition timing on a 1989 Ford Aerostar?
This depends on whether the engine is equipped with a distributor or with EDIS (Electronic Distributorless Ignition System). If EDIS, there is essentially no adjustment. If distributor, you remove the engine cover inside the vehicle and loosen/turn the distributor like any other. Get an aftermarket manual such as Chilton or Haynes for detail of procedure.
You need to know how to change the ignition key switch on a 1989 town car?
LOCKSMITH CHEAP QUICK
Key code location for 1989 Chevy S10?
On original key knock out and on the side of the ignition switch.
Why is there no power to the coil in my 1989 ford f-350 with 460CID?
1- bad relay 2- blown fuse 3- ignition switch 1- bad relay 2- blown fuse 3- ignition switch 1- bad relay 2- blown fuse 3- ignition switch
