remove the front cover, disconnect the turn signals wires and the two nuts that whole the gages, then down under the ignition switch and remove the two Allen screws and disconnect the wiring. install your new one ignition switch in reverse to the instructions.
I am trying to remove my ignition switch on a 2006 Kawasaki Ninja 650r. On the bottom it has two studs that look like the end of the screw. Are these pressed in.
The key code will be in one of two spots. The first location will be behind the ignition switch, etched into the black metal housing; think between the ignition switch and front fairing. If you do not see your code there, the lower end of your ignition switch will list this code. With a flashlight and your handlebars turned all the way to the left you can read the key code from looking at the ignition switch from the bottom right of the bike. This info was for a ninja 250/500 since you did not specify
if you don't know how to work on it you shouldn't own it
Kawasaki ??
How do you tighten chain on 1995 kawasaki ninja zx6r
What is the average and cost for a kawasaki ninja 250r
Ask a Kawasaki dealer, or try looking on the Kawasaki website.
There are two, you will need to remove the tank to reach them on top of the cylinder head cover.
Most motorcycle ignitions have whats called a "shear bolt" I think, they're designed to "shear" off the hex portion of the bolt when installing the ignition. This prevents theft. Usually to remove the cone type bolt the best way it to use a steal center punch and hit the head of the bolt to turn it counter-clockwise to loosen it. If it is too tight to loosen this way unfortunately the only other option I know of it to drill the bolt out. Good Luck. MotoMedix Ottawa.
Fast :)
Like you stole it!
bout $15,000
Remove the gas tank and the air box cover and then replace the air filter.